
Instrument Operation Press the power button to activate the thermometer. The unit will turn off automatically after 35 minutes to save battery life. Press and hold the power button for 3 seconds to turn off EXEC Mini. To activate the backlight, press the power button once while the instrument is turned on. Press again to turn off.

Insert the stainless steel probe to the desired depth. The measured temperature will be shown on the LCD display within 3 to 4 seconds.
Using MIN/MAX Press the MAX/MIN button to read the last highest / maximum temp measured. Press once more to read the last lowest / minimum temperature measured. Press once more to return to normal display. Press and hold the MAX/MIN button for three seconds then release to reset the memory. MAX and MIN are reset when the unit is powered off.
Battery Installation Replace the battery when low battery symbol ‘Bat’ flashes. Replace with a 3 volt, type CR1632, button-cell battery or equivalent. Use a screwdriver of suitable size to open the battery cover on the back. Install the battery observing the correct polarity, (+) positive side up, sliding the battery under the metal clip. Close the battery cover.
To Select ˚F or ˚C Press the °C/°F button on the back of the thermometer to select the desired temperature unit.
Calibration Trim New from the factory the EXEC Mini should read within ±0.9°F. Normally a calibration adjustment should never be needed. For instructions on performing a one-point calibration trim go to the EXEC Mini webpage at www.thermoworks.com
–40 to 572°F (–40 to 300°C) ±0.9°F (±0.5°C) between 14 to 212°F (–10 to 100°C), ±4.5°F (±2.5°C) between 392 to 572°F (200 to 300°C), otherwise ±2.7°F (±1.5°C) 0.1° °C/°F Approx. 3-4 seconds from ambient to 32°F ±0.9°F After 35 minutes 0.45 H x 0.94 W inches (11 H x 24 W mm), with backlight, automatically rotates 180° 10 seconds 0.29 H x 0.16 W inches (7.5 H x 4.0 W mm) 2.9 L x 0.1 dia.; reduces to 0.67 L x 0.06 (1/16”) dia. inches (76 L x 2.5 dia. mm; reduces to 17 L x 1.5 dia. mm), Thermistor Approx. 0.25 inch (6.4 mm) IP67 3 volt, type CR1632 or equivalent x 1 piece (included) 3,000 hours continuous use 6.32 H x 0.9 W x 0.6 D inches (160 H x 23 W x 15 D mm) 32 to 122°F (0 to 50°C)
Battery Battery Life Product Size Operating Range

Care and Cleaning Clean the probe immediately after each measurement to avoid cross contamination. Do not expose the thermometer body to temperatures over 122°F (50°C). Do not leave inside ovens. Avoid submersing the entire thermometer.
Technical Support For warranty, service, and technical assistance, please contact ThermoWorks’ Technical Support at (801) 756-7705 or email at techsupport@thermoworks.com.
For additional cooking tips and doneness temperatures, and to see the full line of ThermoWorks tools, visit our website at www.thermoworks.com
Beef, Veal & Lamb Roasts, Steaks & Chops
Pork Roasts, Steaks & Chops
BBQ Brisket, Ribs, & Pork Butt
* These temperatures are ideal peak temperatures. Meats should be removed from heat several degrees lower and allowed to rise during resting. ** Chef-recommended temperatures are consistent with many expert sources for taste and safety. USDA-recommended temperatures are 5 to 10°F (2 to 5°C) higher.
Ground Meat: Beef, Veal, & Sausage* 160°F 71°C Chicken, Turkey & Duck (whole or pieces)* 165°F 74°C
Ham (raw) 160°F 71°C Poultry Dark Meat** 175°F 79°C
Ham (pre-cooked) 140°F 60°C Stuffing (in the bird) 165°F 74°C
Egg dishes 160°F 71°C Tuna, Swordfish & Marlin** 125°F 52°C
Casseroles & Leftovers 165°F 74°C Other Fish** 140°F 60°C
Water Temps (at sea level)
Low Simmer 180°F 82°C
Water temp to add active dry yeast 105-115°F 41-46°C Butter: Melted & Cooled 85-90°F 29-32°C
Candy or Sugar Syrup Temps (at sea level)
For service or warranty:
1-800-393-6434 1-801-756-7705 techsupport@thermoworks.com
www.thermoworks.com 741 E. Utah Valley Dr. American Fork, UT 84003
Pages referenced in this manual — manufacturer, support and downloads.
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.