Pages referenced in this manual — manufacturer, support and downloads.
Common problems, likely causes, and what to do.
| Problem | Possible cause | Remedy | |
|---|---|---|---|
| User Code does not unlock lock. | User Code entered is not a valid User Code. | p.2 | |
| User Code does not unlock lock. | Vacation Mode is enabled. Disable Vacation Mode. | p.2 | |
| Nothing happens when numbers are pressed. | Too many incorrect User Codes have been entered. | p.2 | |
| Nothing happens when numbers are pressed. | Wait 30 seconds and try again. If keypad does not respond after 30 seconds, then replace battery. | p.2 | |
| There is a delay before unlock after a valid User Code is entered. | Battery is low and should be replaced. See the Keypad Locks User Guide. | p.2 | |
| blinking but no codes have been entered. | Battery is dead and MUST be replaced. See the Keypad Locks User Guide. 19 User Codes already exist. Delete a User Code before adding a new one. | p.2 | |
| Cannot add a new User Code. | Second User Code entered did not match first User Code entered. The User Code matches the first four digits of the existing Programming Code. | p.2 | |
| Cannot delete a User Code. | Second User Code entered did not match first User | p.2 | |
| Cannot change Programming Code. Cannot delete all User Codes. | Code entered. Second Programming Code entered did not match first Programming Code entered. | p.2 | |
| Cannot change Programming Code. Cannot delete all User Codes. | First four digits of new Programming Code match an existing User Code. Programming Code entered second time is incorrect. Any key other than was pressed immediately | p.2 | |
| Lock will not stay in programming mode. | after the programming code was entered. An incorrect entry was made during the programming process. | p.2 |
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.