EN
Progress logo
Official user manual

Progress PDV9066E

144 pages·26.4 MB·Kitchen Range Hood·PDF·ENJA
Progress PDV9066E
Table of Contents 1 sections EN - INSTRUCTION ON MOUNTING AND USE ShowHide
Page 1 of the Progress PDV9066E user manual — EN - INSTRUCTION ON MOUNTING AND USE
Page 1 · click to enlarge
Page 1

EN - INSTRUCTION ON MOUNTING AND USE

Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fi res caused by not complying with the instructions in this manual, is declined. The hood is conceived for the suction of cooking fumes and steam and is destined only for domestic use.

devices or other fuels. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. The flaming of foods beneath the hood itself is severely prohibited. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite. Accessible parts of the hood may became hot when used with cooking appliance. With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities. The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH). This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the non-observance of the instructions included in this manual. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you

Caution WARNING! Do not connect the appliance to the mains until the installation is fully complete. Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply. Always wear work gloves for all installation and maintenance operations. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance. This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Never use the hood without effectively mounted grating! The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion

Page 2 of the Progress PDV9066E user manual — EN - INSTRUCTION ON MOUNTING AND USE
Page 2 · click to enlarge
Page 2

will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.

with current regulations and positioned in an accessible area, after installation. If it not fi tted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over- current category III, in accordance with installation instructions.

The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environ- mental regulations for waste disposal. For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product.

hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. The hood is provided with a special power cable ; if the cable is damaged, request a new one from Technical Service.

Operation Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.

Use The hood is designed to be used either for

exhausting or fi lter version .

T1. Lights ON/OFF T2. Speed decrease Press “T2” button to decrease the speed from 4 (intensive) to 1. Press “T2” button during operation at speed 1, the hood sets to OFF. T3. Speed increase Press T3 button and the hood sets from OFF to speed 1. Press the button (hood is ON) to increase the the speed of the motor from speed 1 to the intensive speed (timed). Speed 1 LED L1 Speed 2 LED L1+L2 Speed 3 LED L1+L2+L3 Intensive speed (timed) LED L1+L2+L3+L4 flashing

Installation This type of cooker hood must be fi xed to the ceiling. Very heavy product; hood handling and installation must be carried out by at least two persons. The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 40cm from electric cookers and 55cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance

·

Page 3 of the Progress PDV9066E user manual — EN - INSTRUCTION ON MOUNTING AND USE
Page 3 · click to enlarge
Page 3

Note: Speed 4 (intensive timed) remains activated for 5 minutes, after which the hood sets speed 2 automatically T4. Speed timing Speed timing is activated by pressing T4 button, when timing is up the hood switches off. Timing is divided as follows: Speed 1 - 20 minutes (LED L1 flashing) Speed 2 - 15 minutes (LED L2 flashing) Speed 3 - 10 minutes (LED L3 flashing) Intensive speed - 5 minuts (LED L4 flashing) During timed operation press T2 button and the hood quits the timed mode and decreases the speed. Press T3 button and the hood quits the timed mode and increases the speed. Press T4 button and the hood quits the timed mode maintaining the set speed. T5. Filter saturation signal button

charcoal fi lter maintenance. To reset the signal, keep T5 button pressed for 5”. (hood is ON). The hood gives out a “BEEP” and LED L2 stops fl ashing. In case of contemporaneous signalling of both fi lters, LEDs L1 and L2 fl ash alternatively. To reset, carry out the procedure described above for 2 times. The fi rst time it resets the charcoal fi lter signal, the second time it resets the grease fi lter signal.

The charcoal fi lter signal is not active in the standard mode. In case the hood is used in fi lter version it is necessary to enable the charcoal fi lter signal.

Activating charcoal fi lter signal: Set the hood to OFF and press T5 button for 5”. Once the button has been pressed, the LEDs related to the fi lter signals currently active light up. The hood gives out a “BEEP” and LED L2 fl ashes for 2”. LEDs L1 and L2 remain on for about 2” before the hood goes back to OFF. Deactivating charcoal fi lter signal: Set the hood to OFF and press T5 button for 5”. Once the button has been pressed, the LEDs related to the fi lter signals currently active light up. The hood gives out a “BEEP” and LED L2 switches off. LED L1 remain on for about 2” before the hood goes back to OFF.

– Control and ConfigurationSee relevant instructions in the following paragraphs. T6. ON/OFF Suction motor: When hood

is on, it switches off at any speed by pressing button T6. When the hood is off, it switches on at Speed 1 by pressing button T6.

Grease filter signal After 40 hours of operation LED L1 fl ashes. When such signal appears, carry out grease fi lter maintenance. To reset the signal, keep T5 button pressed for 5”. (hood is ON). The hood gives out a “BEEP” and LED L1 stops fl ashing.

Charcoal fi lter signal After 160 hours of operation LED L2 fl ashes. When such signal appears, carry out

Page 4 of the Progress PDV9066E user manual — EN - INSTRUCTION ON MOUNTING AND USE
Page 4 · click to enlarge
Page 4

Grease fi lter Fig. 9-22 This must be cleaned once a month (or when the fi lter saturation indication system – if envisaged on the model in possession – indicates this necessity) using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease fi lter may discolour slightly, but this does not affect its fi ltering capacity.

maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat fi lters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. DO NOT USE ALCOHOL!

Charcoal fi lter (fi lter version only) Fig. 21 The saturation of the charcoal fi lter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease fi lter. In any case it is necessary to replace the cartridge at least every four mounths. The charcoal fi lter may NOT be washed or regenerated.

basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any fi re damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

Replacing lamps Fig. 24 Disconnect the hood from the electricity.

bulbs ensure they are cooled down. Replace with a new 12 Volt, 20 Watt (Maximum) halogen light made for a G-4 base SUITABLE FOR USE IN OPEN LUMINAIRES. Follow package directions and do not touch new light with bare hands.

Maintenance of the panel Fig. 8-23 The perimeter air suction panels are attached to the cooker hood by a series of pins and coupling springs; pull them outwards and detach them from the fastening cable. Clean the perimeter air suction panels as often as the grease fi lters. When refi tting the perimeter air suction panels, ALWAYS reattach the fastening cables. Make sure the panels are attached to the cooker hood properly (snap-fastened).

Maintenance

Ask about the Progress PDV9066E

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Progress PDV9066E

Be the first to ask — other owners or our team will answer.

Original document

Progress PDV9066E manual PDF

144 pages·26.4 MB·Kitchen Range Hood·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…