Instruction/ maintenance manual of the product 3760, 4220, 6850, 6860 Bissell
Go to page of 16
USER’S GUIDE 3760/4220/6850/6860 SERIES Safety Instructions 3 Product Diagram 4 Assembly Instructions 4-6 Operation / Special T ools 6-9 Maintenance 10-13 T roubleshooting 14 Warranty 16 Replacement Parts 15 Consumer Services 15 Lift-Off ® REVOLUTION ™ ug603-5567_3760-6850_905.
2 Thanks For Buying A BISSELL Lift-Off ® Revolution ™ We’re glad you purchased a BISSELL Vacuum. Everything we know about floor care went into the design and construction of this powerful, high-tech home vacuuming system. Y our BISSELL V acuum is well made, and we back it with a limited comprehensive one-year warranty .
3 IMPOR T ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, inc luding the following: READ ALL INSTRUCTIONS BEFORE USING Y OUR UPRIGHT V ACUUM. Always connect to a polarized outlet (left slot is wider than right).
4 C AUTION: Do not plug in your vacuum cleaner until you are familiar with all instructions and operating pr ocedures. Power Switch Crevice T ool Handle Quick Release Cord Wrap Handle Release Pedal Po.
How T o Use This Guide This User’ s Guide has been designed to help you get the most satisfaction from your BISSELL Vacuum. Y ou’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions.
Snap the T elescoping Extension Wand, Crevice T ool, and Combination T ool into stora ge clips as shown. On Board T urboBrush ® (Select Models Only) The T urboBrush Bracket slides onto the Hanger on the front of the Handle.
The Powerfoot on your vacuum can be adjusted to clean several floor surfaces. NOTE: For optimal c leaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. Place Handle in Upright Position.
T urboBrush ® (Select Models) : Use rotating brush action for small areas such as stairs and upholstery . Note: Press gently when using T urboBrush to gain maximum cleaning. T oo much pressure could cause the brush to stop rotating. Deluxe Bare Floor T ool (Select Models): Use for bare floors.
9 Select Models Only The Shoulder Strap may be used while cleaning with the Detachable Canister . T o attach the Shoulder Stra p, wrap the V elcro ends attached to the bottom of the strap securely around the Canister handle as shown. T o obtain maximum strength, overlap the loose ends completely and press securely in place.
Upper T ank Knob T o maintain maximum cleaning performance, the following maintenance steps must be performed: Empty the Dirt Container when the dirt reaches the “Full” line on the front. Check the Upper T ank and Pre-Motor Filters at least once a month and clean and replace as needed.
Unplug the cleaner from electrical outlet. The Pre-Motor Filter protects the motor from dirt partic les. It is located in the slide out tray underneath the Dirt Container . If the filter becomes dirty , pull out the tray , lift out the filter and clean.
Place one end of the new Drive Belt over Motor Pulley and the other end over the Brush in the space between the bristles. Pull the Brush firmly to stretch the Drive Belt and place ends of Brush down into slots on sides as shown. T urn Brush several times by hand to center the Drive Belt.
Low suction or poor pickup may be due to a clog in the vacuum cleaner . If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs. Unplug cleaner from electrical outlet. Empty Dirt Container . Check Upper T ank for build up or clogs.
Vacuum c leaner won’t run P ossible Causes Remedies Power cord not plugged in Check electrical plug Blown fuse/tripped breaker Check/Replace fuse or reset breaker Thermal protector activated Allow cleaner to cool for 30 minutes, see pg.
15 Replacement P arts – BISSELL Lift-Off Revolution Series BISSELL Consumer Services 1 2 3 456 7 8 9 10 12 13 14 For information about repairs or replacement parts, or questions about your warranty , call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.
Warranty 16 This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover , please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below.
An important point after buying a device Bissell 3760, 4220, 6850, 6860 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bissell 3760, 4220, 6850, 6860 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bissell 3760, 4220, 6850, 6860 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bissell 3760, 4220, 6850, 6860 you will learn all the available features of the product, as well as information on its operation. The information that you get Bissell 3760, 4220, 6850, 6860 will certainly help you make a decision on the purchase.
If you already are a holder of Bissell 3760, 4220, 6850, 6860, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bissell 3760, 4220, 6850, 6860.
However, one of the most important roles played by the user manual is to help in solving problems with Bissell 3760, 4220, 6850, 6860. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bissell 3760, 4220, 6850, 6860 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
