Instruction/ maintenance manual of the product ZRX71100WA Zanussi
Go to page of 12
EN User manual Refrigerator ZRX71100WA.
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _.
ponents of the refr igerant circuit become damaged. If the refrigerant cir cuit should become dam- aged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way.
• The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is accessible after the installation of the appliance.
Important! Do not use de tergents or abrasive powders, as these will damage the finish. Daily use Using of the ice-maker com partment This appliance is equipped with an ice-maker compartment. In the ice-maker compartment can be reached -2 °C or lower temperature depending on set- ting of thermostat control.
Care and cleaning Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbon s in its cooling unit; maintenanc e and recharg- ing must therefore only be carried out by au- thorized technicians.
Warning! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electric ian or competent person must do the troubleshooting that is not in this manual. Important! There are some soun ds during normal use (compressor, refrige rant circulation).
Problem Possible cause Solution There is too much frost. The door is not closed correct ly. Refer to "Closing t he door". The temperature regu lator is not set correctly. Set a higher tem perature. Closing the door 1. Clean the door gaskets.
Using fine strokes of hammer put them in their place . Location The appliance should b e installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
1 2 1. Remove the plug from the power sock- et. 2. Remove the top hinge cover. 3. Unscrew the 2 re - taining screws, and re- move the hinge from the appliance. 4. Take the door off. 5. Remove the screw fixing the lower door hinge and the other screw fixing the lower door hinge and the foot.
Important! The wires in the mains lead are coloured in accordance with the following code: A Green and Yellow: Earth C Brown: Live D Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the col- oured markings identifying the terminals in your plug, proceed as follows: 1.
www.zanussi.com/shop 212000171-A-452012.
An important point after buying a device Zanussi ZRX71100WA (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Zanussi ZRX71100WA yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Zanussi ZRX71100WA - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Zanussi ZRX71100WA you will learn all the available features of the product, as well as information on its operation. The information that you get Zanussi ZRX71100WA will certainly help you make a decision on the purchase.
If you already are a holder of Zanussi ZRX71100WA, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Zanussi ZRX71100WA.
However, one of the most important roles played by the user manual is to help in solving problems with Zanussi ZRX71100WA. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Zanussi ZRX71100WA along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
