Instruction/ maintenance manual of the product RC68+ Xantech
Go to page of 5
1 Amplifiers & Preamplifiers RC68+ INST ALLA TION INSTRUCTIONS RC68+ PROGRAMMER / REMOTE CONTROL The RC68+ programmer is a 55 key hand-held device that generates all the IR codes necessary for the set up and operation of Xantech IR remote controlled products.
2 RC68+ COMMAND DEFINITIONS • For detailed information that defines the button commands relating to each overlay, refer to the Installation Instructions that come with each specific Xantech model. • The only exception to this is for the model ZPR68; complete command definitions for it are included on the pages that follow.
3 Amplifiers & Preamplifiers RC68+ 9. BALANCE buttons. When the BALANCE "arrow" buttons are pressed, the audio output will move to the left or right (with a 2 dB/step reduction in the attenuated channel) with each left or right press.
4 RC68+ CODE GROUP SETTING PROCEDURES Use these procedures to: a) Select the Code Group Number on the RC68+ to match the Code Group Number internally preset at the factory for the specific Xantech model you wish to control. b) Change the Internal Code Group Number of a Xantech model.
5 Amplifiers & Preamplifiers RC68+ 2. Using a small blade screwdriver, rotate each of the two Code Group Setting Switches on the rear of the RC68+ to the F position ( FF ). See Fig. 5 . 3. Turn the remote over and locate a Code Group number that is different than any other Xantech model used in the same system (i.
An important point after buying a device Xantech RC68+ (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Xantech RC68+ yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Xantech RC68+ - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Xantech RC68+ you will learn all the available features of the product, as well as information on its operation. The information that you get Xantech RC68+ will certainly help you make a decision on the purchase.
If you already are a holder of Xantech RC68+, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Xantech RC68+.
However, one of the most important roles played by the user manual is to help in solving problems with Xantech RC68+. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Xantech RC68+ along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
