Instruction/ maintenance manual of the product RTS-80B Winegard
Go to page of 12
1 RoadT rip ® Minimax TM Stationary Automatic Satellite TV Antenna Model RT8000S (white dome) Model RT8035S (black dome) WINEG ARD ® Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 800/788-4417 • F AX 319/758-5854 • www .winegard.
2 Parts Included • T ools Needed • Unpacking the Unit 1 Dome 1 base with electronics, dish, dual LNBF *Aftermarket versions also include all mounting hardware and cabling required for a single receiver installation P ARTS INCLUDED*: USE 2 PEOPLE when removing the unit from the carton.
3 DISH NETWORK HYBRID 1 2 3 4 5 6 7 8 0 = UP 1 = DOWN KEY BELL TV 1 2 3 4 5 6 7 8 FIGURE 1 4. After selecting location for unit (see Step 2), place the unit on the centerline of the vehicle. 5. Position base so that cables exit toward the rear of vehicle.
4 7. Clean roof area where the base feet will be attached to the roof. Do not erase your marks! 8. Put approved sealant in the areas marked for the base feet. Place base feet on top of the sealant and screw down with the (3) #10 screws for each foot. 9.
5 STEPS 2 & 3 TWO GROUND WIRES 1 FROM VEHICLE 1 BLACK WIRE FROM SA TELLITE DISH STEPS 4 & 5 RED POWER WIRE FROM DISH STEPS 6 &7 +12 V FROM VEHICLE ON/OFF ROCKER SWITCH WITH LIGHT ( Shown in OFF position. ) FIGURE 7 Connecting TWO receivers 1.
6 Basic RoadT rip Minimax Antenna Wiring TV RECEIVER 120V POWER SA T IN POWER 12VDC RoadT rip Minimax ANTENNA COAX COAX DIRECTV must be set to the “two” satellite, oval dish setting. In some cases, the two satellite option may not be available. When this happens, use the three satellite option.
7 If a switch other than SW64 appears, or you have an X in one of the boxes below the satellites, repeat Check Switch Steps. 5. Y our system is now set up to toggle between satellites. It will automatically move to the correct satellite when a channel is selected with your remote control.
8 The RoadT rip Minimax antenna does not attempt to nd a satellite or it never moves. The dish never stops on any of the signals that it sees. 1. Check +12 V wires at unit to verify the quick disconnect is locked into the socket. 2. Make sure the RoadT rip Minimax antenna is plugged in.
9 Appendix A Satellite Coverage Maps and Receiver Compatibility A.1 DISH NETWORK PROGRAMMING The RoadT rip Minimax antenna will operate with most DISH Network receivers. Winegard does not recommend using receivers with hard drives not recommended by the manufactuer for mobile applications.
10 DISH Network satellite 129 ° coverage area (Dotted area indicates coverage).* DISH Network satellite 61.5 ° coverage area (Dotted area indicates coverage).* *Coverage maps are for reference only and do not guarantee coverage. *Coverage maps are for reference only and do not guarantee coverage.
11 A.2 DIRECTV PROGRAMMING The RoadT rip Minimax antenna will operate with most DIRECTV receivers. The antenna will locate and continually track satellites 101° and 1 19°. However , the RoadTrip Minimax is not compatible with the DIRECTV 1 10° satellite or the KA band satellites 99° and 103°.
12 Features and specications • One button operation • Supports up to 2 single or 1 dual receiver . • Depending on receiver type and location, you can access satellites DISH Network 129°, 1 19°, 1 10° or 61.5° DIRECTV 1 19° or 101° BELL TV 91° or 82° • Depending on programming, can access DISH NETWORK’s East Coast local feeds.
An important point after buying a device Winegard RTS-80B (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Winegard RTS-80B yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Winegard RTS-80B - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Winegard RTS-80B you will learn all the available features of the product, as well as information on its operation. The information that you get Winegard RTS-80B will certainly help you make a decision on the purchase.
If you already are a holder of Winegard RTS-80B, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Winegard RTS-80B.
However, one of the most important roles played by the user manual is to help in solving problems with Winegard RTS-80B. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Winegard RTS-80B along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
