Instruction/ maintenance manual of the product MV-4002 Winegard
Go to page of 12
1 Movin’ View TM Digital Satellite Mobile Antenna for Two Receivers for Use While Stationary or In-Motion Model MV-4002 Made in the U.S.A. U.S. Patent Nos. 6,023,247; 6,188,300 Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.
2 DIRECTV ® is an official trademark of DIRECTV , a unit of GM Hughes Electronics Corporation. DISH Network TM is an official trademark of EchoStar Communications Corporaton.
3 2. Determine which programming you will be using. This will determine how you set your switches. For DISH Network set switches to 1 19° . For ExpressV u ® , set switches to 091° .
4 Operation 1. T urn on receiver and television set. The MV -4002 must be connected to a receiver that is plugged into 120 V AC. 2. V erify that you are getting the receiver ’ s menu screens on the television. These screens are avail- able with or without the dish finding the signal.
5 To toggle between satellites when subscribing to multi-satellite programming— While in Sleep Mode , the MV -4002 will toggle be- tween the primary and seconday satellites for either DISH Network or DIRECTV . Both have program- ming on more than one satelite.
6 1 . Open box and remove packing material. 2. Lift unit out of box vertically . Do not turn box and “roll” out, or turn upside down to remove. 1 large yellow spade connector 2 small red spade con.
7 Base Diagram FIGURE 2 CONTROL BOX (DETAIL BELOW) COAX CABLE AT CONTROL BOX CONTROL BOX TO LNBF AZ MOTOR GPS ANTENNA FOOT MUST BE PARALLEL TO THE CENTER LINE OF THE VEHICLE LNBF VOLTAGE +12VDC POWER .
8 Installation IMPORT ANT! Do not install this system in the rain, or under any wet conditions . Mois- ture may affect electronics and void your warranty! 1. For best performance and to reduce signal ac- quisition time, park vehicle on a level surface; level the R V .
9 1. Decide the best location for the cables to enter the vehicle, and the location of the switch and receiver (see “Installing the switch and receiver”on page 10). Drill a 1/2” hole in the roof, push wires inside. Make proper connections. Y ou must have filtered +12 VDC power source .
10 Installation • Wiring Initializing — 1. Be sure vehicle is in a location free of all obstruc- tions and with a clear view of the southern sky . 2. DO NOT MOVE VEHICLE during the first initialization. Power up unit, turn on receiver . FOR THE FIRST TIME ONL Y , the unit may take up to 10 minutes to initially find the satellite signal.
11 Troubleshooting The MV -4002 does not attempt to find a satellite or it never moves. The MV -4002 turns on and moves for a few seconds then stops and never moves again. The dish never stops on any of the signals that it sees. 1. Check your Power switch to verify that it is in the ON position.
12 Winegard Company • 3000 Kirkwood S treet • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www .winegard.com Printed in U.S.A. © 2005 Winegard Company 2452062 Rev .
An important point after buying a device Winegard MV-4002 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Winegard MV-4002 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Winegard MV-4002 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Winegard MV-4002 you will learn all the available features of the product, as well as information on its operation. The information that you get Winegard MV-4002 will certainly help you make a decision on the purchase.
If you already are a holder of Winegard MV-4002, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Winegard MV-4002.
However, one of the most important roles played by the user manual is to help in solving problems with Winegard MV-4002. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Winegard MV-4002 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
