Instruction/ maintenance manual of the product 9900 Wayne-Dalton
Go to page of 8
T orqueMaster™ & i drive™ 9900/9600/9200/9100 INST ALLA TION INSTRUCTION SUPPLEMENT When installing an idrive™ opener with this door use this supplement to the main door instructions as follows: 1) Begin with Step 1 of the main door instructions.
® Follow the corresponding steps in this insert with the steps in the installation manual provided with the door . These modifications are designed to accommodate the new i drive™ garage door opener .
TORQUE TUBE PLUG MOTOR INTO THE OPENER POWER HEAD SLIDE OPENER POWER HEAD LABEL (LEFT SIDE) TORQUE TUBE INSERT THIS END FROM LEFT SIDE OF OPENER Continue sliding the opener power head onto the torque tube.
Refer back to the main door manual and continue door installation at the REAR SUPPOR T INST ALLA TION S tep 18. ( S tep 19 in the Single Spring T orqueMaster™ Installation Instructions) After door i.
Drum Installation TORQUE TUBE WINDING SHAFT DRUM TORQUE TUBE LOOSE WINDING SHAFT DRUM WINDING SHAFT GROOVE ROUND NOTCH FLAG ANGLE Shake the torque tube gently to extend the winding shafts out about 5" on each side. For single spring applications, there will be no left hand winding shaft in the torque tube.
Using the emergency disconnect, pull disconnect handle downwards and place it in the manual door operated position. Use disconnect label for reference. Motor will be rotated 90° from its packaged position. NOTE: If motor does not pivot 90°, see troubleshooting section in the i drive™ main installation manual.
Slide the right hand end bracket over the drive gear . Attach end bracket and the flagangle to the jamb with (2) 5/16 x 1-5/8” lag screws. (see Fig. 1 1 ) 5 OPENER POWER HEAD SPRING P AD TORQUE TUBE MOUNTING STUDS Power Head/ Support Bracket Installation (2) 2” LAG SCREWS SUPPORT BRACKET MOTOR (2) 1/4-20 FLANGE NUTS Locate the spring pad.
power head. W ith slack removed, secure bottom of handle bracket with (1) 1/4 x 1-1/2" lag screw . CAUTION : Pull handle just enough to remove the cable slack. Pulling the cable more could cause the opener power head to disconnect from the torque tube.
An important point after buying a device Wayne-Dalton 9900 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Wayne-Dalton 9900 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Wayne-Dalton 9900 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Wayne-Dalton 9900 you will learn all the available features of the product, as well as information on its operation. The information that you get Wayne-Dalton 9900 will certainly help you make a decision on the purchase.
If you already are a holder of Wayne-Dalton 9900, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Wayne-Dalton 9900.
However, one of the most important roles played by the user manual is to help in solving problems with Wayne-Dalton 9900. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Wayne-Dalton 9900 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
