Instruction/ maintenance manual of the product FD7130 Vivotek
Go to page of 14
Quick Installation Guide This guide describes the basic functions of FD7130 All detailed information is described in the user's manual. FD7130 IP Surveillance V andal-proof .
EN - 1 English Power off the Network Camera as soon as smoke or unusual odors are detected. Contact your distributor in the event of occurrence. Keep the Network Camera away from water . If the Network Camera becomes wet, power off immediately . Do not place the Network Camera around heat sources, such as a television or oven.
EN - 2 Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera during a lightning storm. Do not disassemble the Network Camera.
EN - 3 English Software CD FD7130 with an RJ45 or M12 Cable Quick Installation Guide / W arranty Card Screwdriver Alignment Sticker Ground Wire / Screws Liquid Tight Connectors for RJ45 or M12 Cable P.
EN - 4 Network Camera Model No: FD7130 Made in Taiwan This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
EN - 5 English 1 2 3 4 5 6 7 8 (D) (B) (C) (A) (E) Cabling Assembly 3 Components of the W aterproof Connector Screw Nut (C) Housing (D) Gasket (E) Seal (B) Sealing Nut (A) RJ45 Cable Dimension (unit: mm) Prepare an Ethernet cable and strip part of the sheath.
EN - 6 1 2 3 4 5 6 7 Ø4.5mm~Ø6.5mm (C) (D) (B) (A) (E) M12 Cable Connector Components of the W aterproof Connector M12 Cable Dimension (unit: mm) Assembling Steps Clamp Ring (C) Gasket (D) Plastic Nut (E) Seal (B) Sealing Nut (A) Prepare an Ethernet cable and strip part of the sheath.
EN - 7 English First, use the supplied screwdriver to detach the dome cover from the camera base. Insert your MicroSD/SDHC Card if necessary . Then, follow the steps below to install the camera to either the ceiling or the wall: 1. Attach the supplied alignment sticker to the ceiling/wall.
EN - 8 1 2 B A 3 4 Wall Mount Installing the Ground Wire As shown in the following figure, please secure one side of the supplied ground wire to the screw hole, then route the other side of the ground wire to the ground. Please secure the screws tightly to avoid moisture.
EN - 9 English Network Deployment 5 Po wer ov er Ether net (PoE) POWER COLLISION LINK RECEIVE PARTIT ION 1 2 3 4 5 PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.
EN - 10 Network Camera Model No: FD7130 Made in T aiwan This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
EN - 1 1 English For further setup, please refer to the user's manual on the software CD. Ready to Use 7 1. Access the Network Camera on the LAN. 2. Retrieve live video through a web browser or recording software. T o adjust the viewing angle Adjust the lens to a desired viewing angle as the diagram shown below .
EN - 12 Attach the dome cover to camera. Secure the dome screws with the supplied screwdriver . Finally , make sure all parts of the camera are securely installed. Completion 9 Fine-tune the Camera Focus The focus of this network camera is set from 1.
P/N: 625008801G Ver.1.1 Copyright 2009 VIVOTEK INC. All right reserved..
An important point after buying a device Vivotek FD7130 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Vivotek FD7130 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Vivotek FD7130 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Vivotek FD7130 you will learn all the available features of the product, as well as information on its operation. The information that you get Vivotek FD7130 will certainly help you make a decision on the purchase.
If you already are a holder of Vivotek FD7130, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Vivotek FD7130.
However, one of the most important roles played by the user manual is to help in solving problems with Vivotek FD7130. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Vivotek FD7130 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
