Instruction/ maintenance manual of the product 220/240 Vita-Mix
Go to page of 13
220/240 and 1 00 V AC Models © 2001 Vita-Mix Corporation. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy , recording or any information storage and retrieval system without the written permission of the Vita-Mix Corporation.
13. Always operate with the lid in place. 14. W ARNING: When processing hot liquids: • The 2-part latching lid must be securely in place. This allows steam to escape naturally , and will prevent the lid from coming off when the machine is turned on.
T ouch and Go TM Blending Station ® ON/OFF switc h - Located on the side of the Motor Base the ON/OFF switch controls the power to the machine. With the machine plugged in, switch the machine to ON to ready the machine for blending. ST AR T/ST OP b utton - Pressing ST AR T/ST OP once star ts and r uns the machine and turns the blades.
6 7 4. Within 10 seconds the SIX PRE-SET buttons will be re-programmed and the DISPLA Y WINDOW will read ‘Saved’ then ‘ Ready’. If nothing happens when the programming chip is fully inserted, turn the chip in the opposite direction and try again.
IN-COUNTER HOLE Cut 14 cm wide x 19 cm deep 19 cm deep 14 cm wide 30.48 cm 30.48 cm Additional Unit (if applicable) Additional Unit (if applicable) 24.
THREE PRONG AD APTERS ARE NOT T O BE USED IN CANADA. 10 11 lending T ips 1. If your recipe freezes up, try reducing the amount of ice. Compared to other blenders, you do not need as much ice to make an equally frozen drink in a T ouch and Go TM Blending Station.
T amper Tw o - part Lid 1.5 Liter P olycarbonate container The two part lid is easy to clean and easy to put on, take off and seal. • T o remove fully latched lid, squeeze tabs together on both sides of the container , pull upward and off. • T wist the center lid plug to fasten or remove.
4. Select desired programmed setting by pressing any of the Pre-Set Buttons 1 through 6. The machine will begin immediately to cycle through the selected program, and turn off when the program is complete. Each button has a different pre-selected combination of speed and length for blending.
1. Follow steps one through three of ‘Using The Pre-Set Programmed buttons’ section on page 14. 2. The speed of the motor can be changed with: 3. The PULSE buttons can also be used to temporarily increase the motor speed or decrease the motor speed.
Item# Part #752 2 liter - Container without lid assembly or blade assembly #755 2 liter - Lid plug #756 2 liter - Container , blade assembly & lid assembly #1 191 2 liter - 2-piece lid assembly #1 192 2 liter - Lid only (no plug) PLS145 2 liter - 1-piece non-latching rubber lid #1 159 1 .
Container 1. T o clean: Fill pitcher 1/4 full with warm (43˚C) water and add a couple drops of dish soap. * Return container to motor base and firmly position the two part lid. Run machine for 30 seconds. Empty container . Repeat this step. * NO TE: Polycarbonate container , cover and thermoplastic rubber lid are dishwasher safe.
T roubleshooting 22 23 Cooling the motor: If the machine has o verheated: • The motor will stop and the message “MOT OR HAS OVERHEA TED REMOVE THE CONT AINER, THEN PRESS ST ART”, will scroll across the display window , while the words “HOT SHUTDOWN” will remain in the display window alerting you of the problem.
© 2001 Vita-Mix Corporation. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy , recording or any information storage and retrieval system without the written permission of the Vita-Mix Corporation.
An important point after buying a device Vita-Mix 220/240 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Vita-Mix 220/240 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Vita-Mix 220/240 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Vita-Mix 220/240 you will learn all the available features of the product, as well as information on its operation. The information that you get Vita-Mix 220/240 will certainly help you make a decision on the purchase.
If you already are a holder of Vita-Mix 220/240, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Vita-Mix 220/240.
However, one of the most important roles played by the user manual is to help in solving problems with Vita-Mix 220/240. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Vita-Mix 220/240 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
