Instruction/ maintenance manual of the product VEC088 Vector
Go to page of 12
.
PERSONAL PRECAUTIONS AND SAFETY PERSONAL PRECAUTIONS AND SAFETY 1. Someone sh ould be within range of your voice or close enough to come to your aid when you wor k near a lead-acid battery. 2. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
3 PREPARING TO CHARGE 1. Determine voltage of battery by referring to car owner s manual. 2. if it is nec essary to remove battery from vehicle to charge, or to clean terminals, always remov e grounded termina l from battery first. Make sure all accessories in the vehicle are off, so as not t o cause an arc.
Stage One BEEP BEEP Three COMPLETE LED LIT INTRODUCTION AND FEATURES Thank you for selecting the Vector Model VEC088 2/6/12 Amp 12 volt Smart Battery Charger, with Alte rnator Voltage Check and Battery Recondition modes. With proper care and use, it will giv e you years of dependable service.
.
.
CHARGE RATE SELECTION CHARGE RATE SELECTION Afte r the clamps are connected, plug in the charger to an AC outlet and the charger will show a circulat ing pattern on the Digital Display. This pattern indicates power is a p plied. Press the ON/OF F button to prepare the charger to change to an operating mode.
CONNECTING IF BATTERY IS OUTSIDE OF VEHICLE CONNECTING IF BATTERY IS OUTSIDE OF VEHICLE a ) Check polarity of battery posts- For top-mounted battery connectors, the positive post (marked POS , P, +) usually ha s a larger diameter than the Negative battery post (marked NEG, N, - - ).
VEC088 VEC088 9 9 ALTERNATOR VOLTAGE CHECK ALTERNATOR VOLTAGE CHECK NOTE: NOTE: This check may not be accurate for every make, manufacturer and model of vehicle. There i s wid e variation in user-controlled electrical loads, alternator output, and wiring.
VEC088 VEC088 10 10 TROUBLESHOOTING TROUBLESHOOTING - FAULT LED LIT FAULT LED LIT NOTE: NOTE: Batteries below 4.0 Volts will not allow the charger to operate. if a 12 Volt battery is below 4. 0 Volts it is probably either shorted, open or sulfated. Replace the battery.
VEC088 VEC088 11 11 APPENDIX A APPENDIX A — CHARGING TIMES CHARGING TIMES To calculate t he approximate charging time required to fully charge a battery, it is necessary t o determine the specific gravity (or, percent of battery charge) using a hydrometer.
VEC088 VEC088 12 12 VECTOR 5 YEAR LIMITED WARRANTY PROGRAM VECTOR 5 YEAR LIMITED WARRANTY PROGRAM This limited warranty pro ram is the only one that a p plies to this product, and it sets forth all the responsibilitie s of Vector Manufacturing, Lt ! , regarding this product.
An important point after buying a device Vector VEC088 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Vector VEC088 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Vector VEC088 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Vector VEC088 you will learn all the available features of the product, as well as information on its operation. The information that you get Vector VEC088 will certainly help you make a decision on the purchase.
If you already are a holder of Vector VEC088, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Vector VEC088.
However, one of the most important roles played by the user manual is to help in solving problems with Vector VEC088. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Vector VEC088 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center