Instruction/ maintenance manual of the product XC-360 Uniden
Go to page of 16
q @ .-- I ==: --- 0 0 D c::D GJ)G])@ GJ)G)Q GJGJG) 0@J)@) uniden@ XC-360AUS Cordless Telephone Operating Guide (Australian Edition) ~Idm XC-360 ~o.
CONTENTS Features 3 Read this before Installation 3 Installation 4 Selecting a Location 4 InstallingtheBase 4 InstallingtheBattery 5 ChargingtheBattery 5 Setting the Power On/Off Switch 6 Setting the .
F EATU RES Your Uniden XC-360AUS Cordless Telephone uses the latest cordless telephone technology to make the phone less susceptible to outside in- terference.
INSTALLATION SELECTING A lOCATION Select a location that is all of the fol- lowing: . Near an AC outlet . Near a telephone socket . Out of the way of normal activities . Away from electrical machinery, electrical appliances, and metal walls or filing cabinets .
INSTAlliNG THE BATTERY Follow these steps to install the supplied battery into the handset. Then, charge the battery as described under "Charging the Battery." 1. Use a small Phillips screwdriver to remove the screw that secures the battery compartment cover.
Also, check the charging contacts on the handset and base. If the contacts are dirty or tarnished, clean them with a pencil eraser. . A full charge lasts about one day with the handset on in the standby mode. Be sure to return the hand- set to the base when you see the BATT LOW indicator light.
OPERATION Set the handset's POWER ON/OFF switch to ON. For best reception, fully extend the base's antenna and posi- tion it vertically. To make a call, lift the handset and press the handset's TALK/HANGUP button so that the TALK/HANGUP indi- cator lights.
PAGING When you press PAGE on the base, the handset sounds a tone. You can use this feature to page someone who is in the same room as the hand- set, or to help you locate the handset when it is away from the base. . Note: If the handset's POWER ON/OFF switch is OFF or the TALK indicator is on, the page tone does not sound.
MEMORY DIALING You can store up to 30 telephone numbers in memory. You can then dial a stored number by pressing one of the one-touch dial keys or entering a two-digit, mem- ory-location code. Each number you store can be up to 16 digits long. Storing a Number in Memory To store a number in memory, do the following.
Notes: . If you receive a call while you store a number in memory, press TALK/HANG UP to answer the call. After the call, begin again at Step 2 to store the number. . For each number you store, write the person's or company's name next to the appropriate location number on the memory index card.
TROUBLESHOOTING CHART We do not expect you to have any problems with your phone, but if you do, the following guidelines might help. If you still have problems, take the phone to your local Uniden store where their personnel will assist you and arrange for service if needed.
PROBLEM CAUSE SOLUTION The phone does The handset is too far I Move the handset nearer the not work or works away from the base. base. poorly. 12 The phone line cord and I Properly connect the phone the AC adapter are not line cord and the AC adapter.
MAINTENANCE CARE Your Uniden XC-360AUS Cordless Telephone is an example of superior design and craftsmanship. The follow- ing suggestions will help you care for your phone so that you can enjoy it for years. Keep the phone dry. If it does get wet, wipe it dry immediately.
PLEASE NOTE: Your phone might cause TV or radio interference even when it is operating properly. In the unlikely event that this happens try to determine whether your phone is causing the interfer- ence by turning off your phone. If the interference goes away, your phone is causing the interference.
SPECIFICATIONS FOR AUSTRALIA Australian OPERATING FREQUENCIES Channel Base TX (Handset RX) 30.175 MHz 30.200 MHz 30.225 MHz 30.250 MHz 30.275 MHz 1 2 3 4 5 GENERAL Handset TX (Base RX) 39.875 MHz 39.900 MHz 39.925 MHz 39.950 MHz 39.975 MHz Sensitivity Base 0.
WARRANTY Uniden XC-360AUS Australian 1 Year Warranty. (Batteries and Accessories are covered for 90 Days only). Note: Please keep your sales docket as it provides evidence of warranty.
An important point after buying a device Uniden XC-360 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Uniden XC-360 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Uniden XC-360 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Uniden XC-360 you will learn all the available features of the product, as well as information on its operation. The information that you get Uniden XC-360 will certainly help you make a decision on the purchase.
If you already are a holder of Uniden XC-360, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Uniden XC-360.
However, one of the most important roles played by the user manual is to help in solving problems with Uniden XC-360. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Uniden XC-360 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
