Instruction/ maintenance manual of the product SD-W1101 Toshiba
Go to page of 8
SD-W1101 D VD-RAM with REALmagic Hollywood+ Playback Card Installation Instructions Congratulations on your purchase of a T oshiba SD-W1101 D VD-RAM driv e and REALmagic Hollywood+ D VD/MPEG-2 Playbac k Car d Kit. The following information will help you in the simple installation of your ne w DVD-RAM.
The follow steps must be performed to properly install your D VD-RAM. l Set D VD-RAM driv e jumper settings. l Connect audio cable. l Install SCSI host adapter board. l Attach SCSI interface cable. l Connect power cable. l Mount D VD-RAM. SETTING JUMPERS The block of mode select jumpers are located on the rear of the D VD- RAM.
T est - This setting is for manuf acturer use only . Do not jumper . T erminator ON/OFF - This jumper turns termination po wer ON or OFF . If you are connecting more than one SCSI device to your system, and the D VD-RAM is not at the end of the chain, then terminator jumper is not required.
4 Daisy-Chaining - If the D VD-RAM you are installing is one of two or more SCSI devices you are connecting to your system, you will need to use a custom built SCSI interface cable. Remember that the terminator jumper on the D VD-RAM dri ve must ha ve the jumper installed when the drive is the last device in the chain.
5 Audio Cable (optional) - If you have a sound card and speakers, and would lik e to play audio CDs on your computer , you will need to get a sound cable. Contact AMC, our small parts supplier , at 888/262-9700. Sound cables are made for the sound card you are using and the D VD- RAM to which you are connecting.
6 U SING “W RITE D VD” After installing software, your D VD-RAM drive will be assigned tw o drive letters. One will be for “read only” media (a CD icon) and the other will be for “D VD-RAM” media ( a removab le disk icon). Use your D VD- RAM drive just like any other drive on your system.
7 D VD-RAM RECORDING CAR TRIDGE When recording a D VD-RAM, you must use a “recording” cartridge. There are two types of cartridges: T ype 1: • Cartridge is re versible (side A & B). • Disc cannot be removed from cartridge. • Cartridges are available with single-sided* or double-sided discs.
SD-W1101 SPECIFICA TIONS Data Capacity DVD-RAM (single & double) 2.42 GB DVD-R 3.9 GB D VD-ROM SINGLE SIDED-SINGLE LA YER 4.7 GB D VD-ROM SINGLE SIDED-DOUBLE LA YER 8.
An important point after buying a device Toshiba SD-W1101 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Toshiba SD-W1101 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Toshiba SD-W1101 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Toshiba SD-W1101 you will learn all the available features of the product, as well as information on its operation. The information that you get Toshiba SD-W1101 will certainly help you make a decision on the purchase.
If you already are a holder of Toshiba SD-W1101, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Toshiba SD-W1101.
However, one of the most important roles played by the user manual is to help in solving problems with Toshiba SD-W1101. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Toshiba SD-W1101 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
