Instruction/ maintenance manual of the product BR15A Baumatic
Go to page of 24
BR15A Built-under Larder Fridge.
1 User Manual for your BR15A BUILT-UNDER LARDER FRIDGE NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future reference.
2 YOUR APPLIANCE’S SPECIFICATIONS …….…….3 SAFETY INFORMATION / ENVIRONMENTAL NOTE .. 4 USING YOUR FRIDGE ……………….……………..………5-12 YOUR BR15A FRIDGE …………………….………………….5 BEFORE USING YOUR FRIDGE…………….
Specifications of your BR15A Built-under fridge Con g ratulations on purchasin g built-under fridge! a Baumatic BR15A You r Frid g e has : o Gross capacity: 144 litres o Net capacity: 143 litres o Ene.
4 ELECTRICAL SAFETY • NOTE - This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shoc k by providing a path of least resistance of electrical current. You will be able to tell if it is because a non-grounded appliance will give off an electrical discharge.
5 Your BR15A Built-under Larder-Fridge: KEY A 1 SHELF : The shelves may be placed in any of the guide slots within the interior of the appliance. They are protected from sliding out. To remove a shelf , simply lift the front of the shelf and carefully pull it out of the grooves.
6 UPON DELIVERY: When your Fridge has been delivered, you will need to wait approximately 8 hours before turning it on. The fluid of the compressor installed in the ap pliance will need time to settle. PLEASE DO NOT PLUG IN ANY EARLIER THAN THIS! NOTE : THERE CAN BE AN ODOUR WHEN YOU FIRST SWITCH ON THE APPLIANCE.
7 YOU SWITCH ON YOUR APPLIANCE by PLUGGING IT IN & SETTING THE THERMOSTAT inside the Fridge at the upper right- hand side: Your Fridge’s thermostat automatically regulates the inside temperature of the compartments. By rotating the thermostat knob from a low to a higher number position , colder temperatures can be obtained.
8 Reminder : Allow the unit time to settle after delivery. If your plug and power socket are now behind the fridge and you still need to move the unit into place, be especi ally careful. Remember to leave a safe distance between the back of the fridge and the wall or rear of the unit cabinet.
9 • To reduce humidity and the consequent increase of frost, NEVER place liquids in unsealed containers in the refrigerator. Frost tends to concentrate in the coldest parts of the evaporator. In time, the unit will need more frequent defrosting if too much humidity develops inside it.
10 ALWAYS Cover and wrap foods , especially if they are PUNGENT. • DO NOT place paper or plastic on the shelves which would block the flow of ai r through the grids.
11 NOTE: Before attempting to clean your appliance, UNPLUG IT and make sure you do the following: WE RECOMMEND THAT YOU CL EAN AND MAINTAIN YOUR REFRIGERATOR ONCE A MO NTH. 9 Pay particular attention to the sealing rubber bars of the doors. These need to be kept clean for hygienic reasons as well as to allow the door to close properly.
12 Your appliance is equipped with a sound alarm which will sound to indicate that it is time to clear this dust from the condenser structur e at the back of your appliance. • Disconnect the appliance from the power supply. • If the air opening in the bott om rail of the fridge is obstructed, remove the items responsible.
13 DEFROSTING Defrosting occurs fully automatically in the refrigerator compartment du ring normal operation. The defrosted water collecte d by the evaporating tray evaporates automatically.
14 1) Ensure that you are going to be pla cing your fridge away from heat sources and in a well- ventilated position . This should be at least 3 cm away from electric stoves and 30 cm from oil or coal stoves. Do not place the appliance in the path of direct sunlight.
15 INSTALLING YOUR APPLIANCE- CONTINUE D Fitting Bar Install the Fitting Bar (shown in the picture below) so that it attaches to the top of th e appliance and underneath the top of the cabinetry,indicated by the arrow: * Please be aware that the Fitting Bar is not attached to the appliance and needs to be secured during installation.
16 Fitting the Décor Door 2) Fix the hanging rail onto the inside of the décor door using two 10mm screws, centering it so that 262mm of its width is on either side of the imaginary vertical middle line of the décor door.
17 Adjusting the feet to level your Appliance Adjust the feet (see picture at right) until your Fridge sits levelly on your floor. You can level your unit using these adjustable feet to compensate for dips and rises in your floor surface. NOTE : You can adjust the height from 82 to 90 cm.
18 Reversing the swing of the Door Figure 1 – View of doors Fi gure 2 - View of doorway NOTE : All numbered references apply to both pictures for your convenience. 1) On the hinge-less side of the fridge’s door, remove the caps (1) that cover the hinge bracket holes.
19 6) Attach the door to the doorway, ensu ring that all the holes where the hinges had formerly been screwed into are now covered with the caps you had previously removed.
20 ADDITIONAL NOTE: SHOULD THE CABINET’S SIDE PANEL HEAT UP, THIS IS NORMAL. IT WILL DO THIS IN SUMMER WITH A HIGH AMB IENT TEMPERATURE OR IF THE DOOR HAS BEEN OPENED AND CLOSED FREQUENTLY. IT IS THE RESULT OF HEAT’S DI SSIPATING FROM INSIDE THE CABINET AND IS NOT DETRIMENTAL TO YOUR REFRIGERATOR IN AN Y WAY.
Baumatic Ltd. Conditions of guarantee Dear Customer, Your new Ba umatic appliance com es complete with a free 12 month guarantee cove ring bot h parts an d labour costs resulting from defective materials or workmanship.
Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephone +44 118 933 6900 Sales Fax +44 118 931 0035 Service Telephone +44 118 933 6911 Service Fax +44 118 986 9124 Spares Telephone +44 118 933 6922 Technical / Advice Telephone +44 118 933 6933 E-mail : sales@baumatic.
2 2.
An important point after buying a device Baumatic BR15A (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Baumatic BR15A yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Baumatic BR15A - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Baumatic BR15A you will learn all the available features of the product, as well as information on its operation. The information that you get Baumatic BR15A will certainly help you make a decision on the purchase.
If you already are a holder of Baumatic BR15A, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Baumatic BR15A.
However, one of the most important roles played by the user manual is to help in solving problems with Baumatic BR15A. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Baumatic BR15A along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
