Instruction/ maintenance manual of the product HM100 Tecumseh
Go to page of 8
Page 1 Figure 1 MODEL 3-1-99 181-630-14 181-630-14 ENGINES WHICH ARE CERTIFIED TO COMPLY WITH CALIFORNIA AND U.S. EPA EMISSION REGULATIONS FOR ULGE ENGINES, are certified to operate on regular unleade.
Ä Ä If your engine is equipped with a CLIM ATE GUARD air cleaner, make sure scoop is posi- tioned correctly: • WINTER (Below 32 0 F; 0 0 C): Scoop should be pointed directly at muf- fler. • SUMMER (Above 32 0 F; 0 0 C): Scoop should be pointed towards blower housing (approximately 45 0 clockwise from “winter position”).
STARTING (Continued) Á Á ELECTRIC STARTER: A. Move choke lever (see Figure 3 or 4) to “FULL CHOKE POSITION”. NOTE: IF RESTARTING A WARM ENGINE AFTER A SHORT SHUTDOWN, MOVE CHOKE LEVER TO “NO CHOKE POSITION”. B. Move equipment control (see manufacturer’s instructions) or engine control to “START”.
MAINTENANCE (Continued) Å Å ALTERNATOR AND BATTERY (if so equipped): A. ALTERNATOR: For electrical problems such as inoperative starter or discharged battery see equipment manufacturer’s instructions for fuse replacement, maintenance and repairs. B.
STORAGE NEVER STORE ENGINE WITH FUEL IN TANK INDOORS OR IN ENCLOSED, POORLY VENTILATED AREAS, WHERE FUEL FUMES MAY REACH AN OPEN FLAME, SPARK OR PILOT LIGHT AS ON A FURNACE, WATER HEATER, CLOTHES DRYER OR OTHER GAS APPLIANCE. IF ENGINE IS TO BE UNUSED FOR 30 DAYS OR MORE, PREPARE AS FOLLOWS: À À DRAIN FUEL SYSTEM: A.
FILL IN: ENGINE SPEC. WARRANTY SERIAL MODEL NUMBER PERIOD NUMBER Page 6 EXAMPLE: HM80 155000P (B) 5001A ENGINE SPEC. WARRANTY SERIAL MODEL NUMBER PERIOD NUMBER 181-630-14 LIMITED WARRANTY FOR NEW TECU.
CALIFORNIA & US EPA EMISSION CONTROL WARRANTY ST ATEMENT The U. S. Environmental Protection Agency (“EPA”), the California Air Resources Board (“CARB”) and Tecumseh Products Co. are pleased to explain the Federal and California Emission Control Systems W arranty on your new utility or lawn and garden equipment engine.
Page 8 181-630-14 EMISSION CONTROL SYSTEM WARRANTY Emission Control System Warranty (“ECS Warranty”) for 1995 and later model year California utility and lawn and garden equipment engines (for other states, 1997 and later model year engines): A.
An important point after buying a device Tecumseh HM100 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Tecumseh HM100 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Tecumseh HM100 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Tecumseh HM100 you will learn all the available features of the product, as well as information on its operation. The information that you get Tecumseh HM100 will certainly help you make a decision on the purchase.
If you already are a holder of Tecumseh HM100, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Tecumseh HM100.
However, one of the most important roles played by the user manual is to help in solving problems with Tecumseh HM100. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Tecumseh HM100 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
