Instruction/ maintenance manual of the product B902.1BL-B Baumatic
Go to page of 32
1 B902.1BL-B/B904.1SS-B 60cm Built in electric double oven..
User Manual for your Baumatic B902.1BL-B/B904.1SS-B 60 cm Built in electric double oven NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance.
3 Contents Environmental note 4 Important safety information 5 - 7 S p e c i f i c a t i o n s 8 - 10 Product and aperture dimensions 8 Product specifications 8 - 9 S t a n d a r d a c c e s s o r i e.
Environmental note 4 o Baum atic uses are environmentally friendly and can be recycled. o all packaging mate rial with due regard for the environment. The packaging materials that Please discard.
5 IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If yo are unsure of any of the info rmation contained i booklet, pleas u n this e contact the Baumatic Technical ent.
6 arning and safety instructions o iance become hot during use and re tain heat after operation. hild Safety o appliance and not allowed to touch the appliance at any time. o se ensure that they are kept under close supervision at all times. eneral Safety o en it is open, as th is can cause damage to the oven door hinges.
7 nstallation cordance ith the manufacturer’s instructions. o esult of improper use or installation of this appliance. o s periods of time, then additional ventilation may be required. o any doubt about the amount of ventilation that you will require.
8 pecifications S Dimensions ns mm mm 560 mm o in o e, to oven stable and the e lower. ro u : A s ven and grill o Capacity: 36 litres Product Aperture Dimensio Height: 888 mm 875 mm – 878 Width: 596.
9 multifunction oven o Capacity: 60 litres tandard accessories ks ed drip trays with handle o 2 x Trivets ptional extras SCL.1KIT Stay-clean liners kit (main oven only). lectrical details ated Voltage: 230 Vac 50 Hz Supply Connection: outlet with 3mm contact gap ax Rated Inputs: 4.
10 ontrol Panel C 1) Oven programmer/timer display 2) Secondary oven operating light 3) Secondary oven th ermostat control knob n knob n knob ) Main oven thermostat control knob ven programmer/timer d.
11 etting and using the oven programmer/timer S Selecting manual operation mode After your appliance is connected to your mains supply for the first time, the numbers on the ti mer display will flash.
12 etting the minute minder function (main and secondary oven) nd an alarm ill sound when this period of time has elapsed. o te tdown for, by using the minus (14) and plus (15) buttons. o e minute minder symbol (18) will appear on the timer display. o horten or lengthen the time by using the minus or plus buttons.
13 etting the duration func tion (main oven only) er ontinue to heat, once the countdown period has elapsed. o e manual operation symbol (17) will appear on the display. o n knob (7) to select the mode of cooking that you require. o sible to set the du ration of the cooking time that you require.
14 etting the end cook func tion (main ove n only) elect the time of day that you wish the ven to switch off at. o e manual operation symbol (17) will appear on the display. o n knob (7) to select the mode of cooking that you require. o ed e of day that you have selected and show it on the display.
15 etting the start and end time function (main oven only) ven switches on at and a time th at the oven will switch off a t. o e manual operation symbol (17) will appear on the display. o n knob (7) to select the mode of cooking that you require. o e 5) buttons.
16 ing function and temperature Selecting a cook Selecting manual operation mode After your appliance is connected to your mains supply for the first time, the numbers on the ti mer display will flash. Before you can select a cooking function or set a temperatur e, you u t press the manual operation n oven power dicator light will come on.
17 ner and outer parts of the top element, which directs heat downwards onto the food. This function is suitable for grilling medium or n, steaks, fish etc. c ntrol knob sets the quired temperature of the oven. It is within range of 50 - 230°C. urn the control knob clockwise.
18 o the oven. It is ossible to regulate the temperature within urn the control knob clockwise. are of f when the temperature set on the ermostat control knob has been reached. It will cycle on and off ou should not place food inside either cavity, until the correct e has been reached.
19 o Make sure that frozen foods are thoroughly thawed before cooking, unless the instructions on the food packaging advise that you can “cook from frozen”. o Before cooking, check that any a ccessories that are not required are removed from the oven.
Cleaning and maintenance Cleaning operations must only be carried ou t when the oven is cool. The appliance should be disconnected from your mains supply before commencing any cleaning process. o The oven should be th oroughly cleaned before it is operated for the first time and after each use.
Replacing the oven bulb (main oven) IMPORTANT: The oven must be disconnected from your mains supply before you attempt to either remove or replace the oven bulb. o Remove all oven shelves and the drip tray. o Unscrew the lamp cover. o Unscrew the bulb and remove it from its holder.
o Place the lamp cover back into po sition. There is a curve on one side of the cover; this should be on the right hand side as the cover goes back into place.
INSTALLATION The installation must be carried out by a suitably qualified person, in acco rdance with the current version of the following. o UK Regulations and Safety Stan dards or their European Norm Replacements. o Building Regulations (issued by the Department of the Environment).
Connecting the mains supply cable o The mains terminal block is locate d on the rear of the oven and the terminals are accessible by removing the terminal block cover.
o If when the oven is first swit ched on, it does not function correctly, you should recheck that the terminal scre ws are all fully tightened between the links. This should be done before contacting the Baumatic Service Department. o IMPORTANT: The appliance must NOT be connected to the mains supply by means of a 13A plug and socket.
Installing the oven into the kitchen cabinet Positioning the appliance o Ensure that the aperture that you will be fitting the oven into is of the size given in the above diagram. o The oven must be fitted into an oven housing with the ventilation cut-outs shown in the “Ventilati on requirements” section on the next page.
Ventilation requirements (Figure shows the ventilation an d cut-out requirements for the installation of the appliance into a tall housing unit). o Ensure that the oven has been securely fixed into the housing unit. The fixing of the oven into the housing is made by using four screws.
28 My appliance isn’t working correctly o The oven isn’t coming on. * Check that the oven is in manual operation mode. * Check that you have selected a cooking function and a cooking temperature. o There appears to be no po wer to the oven and grill.
o The oven lights is not working * Refer to page 21 - 22 and follow the “Replacing the oven bulb” section. o I am getting condensation in my oven * Steam and condensation is a natu ral by product of cooking any food with high water content, su ch as frozen food, chicken etc.
30 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Service Telephone (0118) 933 6911 Service Fax (0118) 986 9124 Spares Telephone (01235) 4372 44 Technical Advice Telephone (0118) 933 6933 E-mail: sales@baumatic.
31.
32.
An important point after buying a device Baumatic B902.1BL-B (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Baumatic B902.1BL-B yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Baumatic B902.1BL-B - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Baumatic B902.1BL-B you will learn all the available features of the product, as well as information on its operation. The information that you get Baumatic B902.1BL-B will certainly help you make a decision on the purchase.
If you already are a holder of Baumatic B902.1BL-B, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Baumatic B902.1BL-B.
However, one of the most important roles played by the user manual is to help in solving problems with Baumatic B902.1BL-B. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Baumatic B902.1BL-B along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
