Instruction/ maintenance manual of the product SILEX 75-G Stiga
Go to page of 10
STIGA Silex 75-G Silex 75R-B Silex 75R-H Silex 75R-HX 8214-2212-80 BRUKSANVISNING KÄYTTÖOHJEET BRUGSANVISNING BRUKSANVISNING GEBRAUCHSANWEISUNG INSTRUCTIONS FOR USE MODE D’EMPLOI GEBRUIKSAANWIJZIN.
2 AB C D EF G H LN O R SN O PQ J K M 75-G E J K P Q R A B 75R-H E P R A B J K 1 2 3.
3 75R-HX J K Q E A P B R X Y V U Z S T T L T A B 4 6 8 5 7 9.
41 ENGLISH GB 1 SYMBOLS The following symbols can be found on the rotary cultivator/in these instructions. These will provide a reminder of the care and attention that is required during operation. If any symbol is missing, has been damaged or is illegible, it must immediately be replaced with a new one.
42 ENGLISH GB • W ear tightly fitting clothes and heavy-duty shoes which completely cover the feet. • The tank should only be half full when operat- ing on slopes.
43 ENGLISH GB 3.5 Cable for reverse control Only applies to 75R. The cable is marked R . 1. Pull the cable up under the cover (1:G) and over the handle’ s screws. 2. Hook the cable in the reverse control (1:A) and insert the cable in the gap in the cable housing’ s mounting on the left handle.
44 ENGLISH GB 4.10 Oil draining The screw is removed when used engine oil is to be drained. The screw is shown according to the table below: 4.11 Auxiliary wheel (1:L) The auxiliary wheel is intended to assist transport of the machine and has two positions.
45 ENGLISH GB The different operating properties are shown ac- cording to the table below: 5 OPERATION 5.1 Fuel Read and understand all safety instruc- tions. No fires or smoking near to p etrol. Use 92-95 octane lead free petrol. Oil-mixed petrol designed for 2-stroke engines must never be used.
46 ENGLISH GB The optimum working depth varies with soil con- ditions. The working depth is determined by how hard the depth skid is pushed down during propul- sion. Operate and test. Drive 2-3 times in different directions for best re- sults. Never operate the machine in wet soil.
47 ENGLISH GB 7.4 Changing the oil Change the oil the first time after 2 hours of oper- ation, and subsequently every 25 hours of opera- tion or at least once a season. Change oil when the engine is warm. The engine oil may be very hot if it is drained off directly after the engine is shut off.
An important point after buying a device Stiga SILEX 75-G (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Stiga SILEX 75-G yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Stiga SILEX 75-G - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Stiga SILEX 75-G you will learn all the available features of the product, as well as information on its operation. The information that you get Stiga SILEX 75-G will certainly help you make a decision on the purchase.
If you already are a holder of Stiga SILEX 75-G, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Stiga SILEX 75-G.
However, one of the most important roles played by the user manual is to help in solving problems with Stiga SILEX 75-G. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Stiga SILEX 75-G along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
