Instruction/ maintenance manual of the product SGV 120 10TS State Industries
Go to page of 8
1 1 The storage tank is sold as a component part. It has been factory equipped with a booster element, and thermostat with high limit. The tank is designed to store potable water within the limits listed on the rating plate and to supply domestic hot water up to the element’s heating capability .
2 TYPICAL INST ALLA TION .................................................................................................................................................................. 2 INST ALLA TION ..............................................
3 3 WARNING Never operate the electrical heating element without being certain the tank is completely filled with water . If any air is left in the top of the tank, the heating element will burn out.
4 CAUTION This tank, as all tanks, will eventually leak. Do not install without adequate drainage provisions where water flow will cause damage. Note: normal condensation from a tank may appear to be a leaking tank. W A TER PIPING This tank is design certified to be used with a potable water system.
5 5 WARNING T ANKS EQUIPPED FOR ONE TYPE VOL T AGE ONL Y . This tank is equipped for one type of voltage only . Check the rating plate near the bottom access panel for the correct voltage. DO NOT USE THIS T ANK WITH ANY VOL T AGE OTHER THAN THE ONE SHOWN ON THE MODEL RA TING PLA TE.
6 T emperature Time to Produce 2nd & 3rd Setting Degree Burns on Adult Skin 170°F Nearly instantaneous 160°F About 1/2 second 150°F About 1-1/2 seconds 140°F Less than 5 seconds 130°F About 30 seconds 125°F About 2 minutes 120°F More than 5 minutes FIGURE 7 TEMPERA TURE ADJUSTMENT T o adjust the temperature setting: 1.
7 7 A non-adjustable high temperature limit control operates before steam temperatures are reached. The high limit is in the same area as the upper thermostat and must be reset manually when it operates.
8 REP AIR P ARTS REP AIR P ARTS SCHEDULE ORDERING REP AIR P ARTS The following parts may be ordered through the store you purchased the tank from, or direct from the factory listed on the model & rating plate located on the lower front of the tank.
An important point after buying a device State Industries SGV 120 10TS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought State Industries SGV 120 10TS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data State Industries SGV 120 10TS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, State Industries SGV 120 10TS you will learn all the available features of the product, as well as information on its operation. The information that you get State Industries SGV 120 10TS will certainly help you make a decision on the purchase.
If you already are a holder of State Industries SGV 120 10TS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime State Industries SGV 120 10TS.
However, one of the most important roles played by the user manual is to help in solving problems with State Industries SGV 120 10TS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device State Industries SGV 120 10TS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
