Instruction/ maintenance manual of the product BA-EZ27 Banner American
Go to page of 10
OPERATING INSTRUCTIONS EZ27 R oll Lamina tor Revised October 2, 2003.
TABLE OF CONTENTS Safety Messages and Electrical Safeguards .................................. 1-2 Introduction ...................................................................................... 2-3 Laminator Features .............................
IMPORTANT SAFETY MESSAGES AND ELECTRICAL SAFEGUARDS For your protection, do not connect the laminator to electrical power or attempt to operate it until you read these instructions completely. Keep these instructions in a convenient location for future reference.
Unplug the laminator before moving it or when it is not in use for an extended period of time as a precaution against the possibility of an internal malfunction that could create a fire hazard. Do not operate the laminator with a damaged power supply cord or plug, or after it malfunctions or has been damaged in any manner.
Your EZ27 is preset at the factory for most applications so any adjustments should be minor. A thermometer provides continual indication of the Heat Shoe temperature and may be adjusted as needed. Laminator Standard Features... Preset laminating roller pressure and speed require no adjustment.
INITIAL SETUP Unpacking and assembly ... Before unpacking the unit, inspect the shipping container for signs of damage. Notify the carrier and your dealer immediately if any damage is noted. CAUTION! The laminator , without the feed table and mounting slides installed, weighs approxi- mately 70 lbs.
Machine Drive: This three position (FWD/OFF/REV) switch controls power to the Laminating Rollers. If the switch is pressed to the FWD position the rollers move forward, pulling the plastic film and laminated material past the Heat Shoes. When this switch is pressed to the REV position the rollers move in the reverse direction.
Threading Laminating Film... These instructions apply to poly-in film rolls (shiny side out, dull side in) 1. For the top supply roll place the mandrel ends into the slots in the top of the laminator . If you are facing the front of the laminator the film should unwind toward you from the bottom of the roll as in Figure 3 below .
5. Turn the Machine Drive switch to FWD to start the Laminating and Pull Rollers. 6. Feed a piece of thin cardboard about 10” x 25” against the film so that it is centered between the two Heat Shoes. Push the cardboard and film into the Laminating Rollers.
Setting Heat Shoe Temperature... The laminator temperature should be adjusted according to the film thickness and the item being laminated. See Table 1 below for recommended temperature settings. Keep in mind that the temperatures listed are approximate and different brands of laminating film may require different temperatures.
An important point after buying a device Banner American BA-EZ27 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Banner American BA-EZ27 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Banner American BA-EZ27 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Banner American BA-EZ27 you will learn all the available features of the product, as well as information on its operation. The information that you get Banner American BA-EZ27 will certainly help you make a decision on the purchase.
If you already are a holder of Banner American BA-EZ27, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Banner American BA-EZ27.
However, one of the most important roles played by the user manual is to help in solving problems with Banner American BA-EZ27. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Banner American BA-EZ27 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
