Instruction/ maintenance manual of the product SSWG Bakers Pride Oven
Go to page of 36
Heated Display Merchandisers MODELS WDCG, SSWG, CSWG Installation & Operation Manual.
Warranty Information LIMITED ONE YEAR WARRANTY BKI (The “Company”) warrants to the ori ginal purchase r/user, that at time of shipment from the Company factory, this equipment will be free from defect in materia l s and workmanship.
Hot Food Deli Case Table of Contents 1 T able of Content s Table of Contents .............................................................................................................. .......................... 1 Introduc tion ....................
Hot Food Deli Case Introduction 2 Introduction Congratulations! You have cho se n a Hot Food Deli Case that will give you many years of fine service from the original manufacturer, BKI .
Hot Food Deli Case Introduction 3 Specific Precautions Equipotential Ground Plane When a high current flows throug h a conductor, difference s in potential appear between the conductor and nearby metallic surfa ces near the appliance. As a result, sparks may be produced between the applian ce an d su rrounding metal surfaces.
Hot Food Deli Case Introduction 4 Keep Safety Labels Clean and in Good Condition Do not remove or cover any safety labels on your e quipment. Keep all safety labels clean and in good con dition. Repl ace any damaged or missing safety labels. If you need new safety labels, contact: BKI Technical Services Depart ment P.
Hot Food Deli Case Operation 5 Operation Controls and Indicators The deli case controls are shown in the figure below . The pushbutton switches turn the po wer supply to the case on and off. The touchscre en interface is used to operate t he case and display temperatures.
Hot Food Deli Case Operation 6 Software Controls - Default Screen The Default Screen appears on the tou chscreen during norm al operation. The screen shows the menu button and a representive temperature. The representativ e temperature doe s not correspond to th e internal temperature of the food products in the c ase.
Hot Food Deli Case Operation 7 Software Controls - Programming t he Controller There is a unique set of touches to enter the program ming mode. This prevents the case settings from bei ng inadvertently changed.
Hot Food Deli Case Operation 8 Preheating You should allow the equipment to preh eat at the programmed temperature settings for a mi nimum of 30 minutes before loading it with product. For initial start up, program the controlle r for ea ch well and upper heater to a setting of 5.
Hot Food Deli Case Installation 9 Inst allation Unpacking and Handling YOU are responsible for filling all freight claim s with the deliverin g truck line.
Hot Food Deli Case Installation 10 1. Level the case using the leg levelers at the corner s of the ca se (Figure 1). 2. Raise the low end of the case to level it, do not lower the high end.
Hot Food Deli Case Installation 11 End Panel Mounting 1. Now, attach the End Trim Panels to the base ends. The stud s on the Trim Panels pa ss th rough the mounting holes in the base ends (see Figure 2). Both End Trim Panels are the same. 2. The panels are secured fro m inside with the #10 Pal Nuts provided.
Hot Food Deli Case Installation 12 Pedestal Model Pedestal mounted cases are provide d with a mounting fr ame that runs the full length of the case. This allows the pedestals to be located at any point along the length of the case. Each ca se should be supported by at least two pedestals.
Hot Food Deli Case Installation 13 7. Proceed in the same manner until all the cases in the l ine are level and bolted together. 8. Complete the line up by slipping the Co unter Top Joint Cover over the ends flanges of the adjoining counter tops. Front and Rear Cover Attachment 1.
Hot Food Deli Case Installation 14 Counter Model Counter Mounted case s must be mounted on a level surf a ce that can support the weight of the ca se an d it contents. Use a carpenter’s level as shown in Figure 3 to level the case. These cases are to be seal ed to the counter if required by local he alth codes.
Hot Food Deli Case Maintenance 15 Case Joining Trim 1. After leveling the cases and bolting the bases together, bolt the canopies together as shown in Fig. 6 with a ¼”-20 x ¾” Hex Head Screw and Keps Nut. 2. Mount the Upper Front & Base Front Joint Trim s by holding them in place and marking the h ole locations on t he ca se.
Hot Food Deli Case Maintenance 16 Failure to comply with the maintenance below could result in a serious a ccident. Electrocution, equipment failure or property damage could result if an unlicensed electrician performs electri cal re pai r. Ensure that a licensed electrician perform electrical repair.
Hot Food Deli Case Maintenance 17 Troubleshooting Refer to the table below for troubl eshoot ing information. Problem Cause Possible Solution Electrical No Power to the ca se. Check circuit brea ker or fuse s at building power panel. If problem persists, contact an authori zed BKI service agent for corrective action.
Hot Food Deli Case Wiring Diagrams 18 Wiring Diagrams.
Hot Food Deli Case Wiring Diagrams 19.
Hot Food Deli Case Wiring Diagrams 20.
Hot Food Deli Case Wiring Diagrams 21.
Hot Food Deli Case Wiring Diagrams 22.
Hot Food Deli Case Wiring Diagrams 23.
Hot Food Deli Case Wiring Diagrams 24.
Hot Food Deli Case Wiring Diagrams 25.
Hot Food Deli Case Wiring Diagrams 26.
Hot Food Deli Case Wiring Diagrams 27.
Hot Food Deli Case Wiring Diagrams 28.
Hot Food Deli Case Wiring Diagrams 29.
Hot Food Deli Case Wiring Diagrams 30.
Hot Food Deli Case Wiring Diagrams 31.
Hot Food Deli Case Wiring Diagrams 32.
Hot Food Deli Case 33 No t es.
P.O. Box 80400, Simpsonvill e, S.C. 29680-0400, USA http://www.bkideas.co m Made and printed in t he U.S.A LI0117/0607.
An important point after buying a device Bakers Pride Oven SSWG (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bakers Pride Oven SSWG yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bakers Pride Oven SSWG - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bakers Pride Oven SSWG you will learn all the available features of the product, as well as information on its operation. The information that you get Bakers Pride Oven SSWG will certainly help you make a decision on the purchase.
If you already are a holder of Bakers Pride Oven SSWG, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bakers Pride Oven SSWG.
However, one of the most important roles played by the user manual is to help in solving problems with Bakers Pride Oven SSWG. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bakers Pride Oven SSWG along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
