Instruction/ maintenance manual of the product Starck 10920001 Axor
Go to page of 8
Starck X 10920001 Installation Instructions / W arranty.
2 T echnical Data Flow rates @ 45 psi Showerhead 2.5 gpm Handshower 2.5 gpm Bodysprays 4.3 gpm Maximum water pressure 145 psi Recommended water pressure: 40 - 75 psi Recommended hot water temp.: 120°F - 140°F* A check valve is installed in the handshower outlet.
3 Preparation The W ater wall requires 1/2” NPT male nipples, extend- ing 5/8” outside the surface of the finished wall for the hot and cold water supplies. For proper operation of the thermostatic mixer , the hot supply should be on the left and the cold supply should be on the right.
4 Push the shower arm into place on the W ater wall. T ighten the set screw , using the Allen wrench (included). Hang the shower wall on the top mounting bracket. With a helper holding the panel, attach the hoses to the elbows. Install the bottom retaining screw and tighten with a screwdriver .
5 Remove the thermostatic mixer handle. Carefully remove the retaining clip and the stop ring from the stem. T ur n the water on to the handshower . Place a thermom- eter in the water stream. T ur n the thermostatic mixer stem until the water coming out is the maximum allowable output temperature (usually 110° - 112°F).
6 User Instructions Using the Thermostatic Mixer : turn the handle clockwise to obtain cooler water and counter- clockwise to obtain warmer water . The handle will stop when the water temperature is 100° - this is the safety stop. T o obtain water than 100°F , push the safety stop override button and continue turning the handle counter-clockwise.
7 Limited Lifetime Consumer W arranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 T el. 770-360-9880 • Fax 770-360-9887 www .hansgrohe-usa.com US - Installation Instructions • Part No.
An important point after buying a device Axor Starck 10920001 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Axor Starck 10920001 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Axor Starck 10920001 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Axor Starck 10920001 you will learn all the available features of the product, as well as information on its operation. The information that you get Axor Starck 10920001 will certainly help you make a decision on the purchase.
If you already are a holder of Axor Starck 10920001, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Axor Starck 10920001.
However, one of the most important roles played by the user manual is to help in solving problems with Axor Starck 10920001. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Axor Starck 10920001 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
