Instruction/ maintenance manual of the product SC106ALU Smeg
Go to page of 29
32 Ta b l e o f C o n t e n t s INSTRUCTIONS FOR THE USER : these pro vide recommendations for use, a description of the controls and the correct procedures for cleaning and maintaining th e appliance INSTRUCTIONS FOR THE INST ALLER : these are intended for the qualified engineer who is to install, commission and test the applia nce 1.
33 Precautions f or use 1. PRECA UTIONS FOR USE THIS MANU AL IS AN INTEGRAL P AR T OF THE APPLIANCE. T AKE GOOD CARE OF IT AND KEEP IT T O HAND THROUGHOUT THE O VEN'S LIFE CYCLE. WE URGE Y OU TO READ THIS MANU AL AND ALL THE INFORMA TION IT CONT AINS CAREFULL Y BEFORE USING THE APPLIANCE.
34 Disposal instructions 2. DISPOSAL INSTRUCTIONS - OUR EN VIR ONMENT POLICY Our products are only packaged using non-pollutant, environment-friendly , recyclable materials .
35 Safety precautions 3. SAFETY PRECA UTIONS REFER T O THE INST ALLA TION INSTRUCTIONS FOR THE SAFETY REGULA TION S FOR ELECTRIC OR GAS APPLIANCES AND VENTILA TION FUNCTIONS.
36 Instructions f or the user 4. GET T O KNO W Y OUR O VEN 5. BEFORE INST ALLA TION CONTROL P ANEL O VEN LIGHT O VEN F AN SHELF AND TRA Y R UNNERS TEMPERA TURE SENSOR ROOF LINER/GRILL GUARD Nev er l eav e packaging residues unattended in the home. Separate waste packaging materials by type and consign them to the nearest separate disposal centre.
37 Instructions f or the user 6. DESCRIPTION OF FRONT P ANEL CONTR OLS All the appliance's control and monitor ing devices are placed together on the front panel.
38 Instructions f or the user FUNCTION-SWITCH ON KNOB PT2 Simply tur n this knob to the right or le ft to select the function required , from those listed below .
39 Instructions f or the user 7. USING THE O VEN 7.1 Precautions a nd General Advice All cooking operations must be carried out with the door c losed When the oven and grill are used for the first tim.
40 Instructions f or the user 7.3 Fir st use At first use, or after a power f ailure, the ov en display (DSP1), will show a flashing symbol. T o star t any cooking operation, the current time must be set. (F or fur ther informatio n about settin g or adjusting th e current time, see point "7.
41 Instructions f or the user W a rn ing. The minute minder does not stop the cooking process. It only warns the user that the preset number of minutes hav e passed.
42 Instructions f or the user 7.5.3 A utomatic cooking Automatic cooking is the function which all ows a cooking operation to be star ted at a set time and then ended after a specific l ength of time set by the user . Select a cooking fu nction, set the co oking temperature required or leav e the preset temperature (see point “7.
43 Instructions f or the user 7.6 Secondary men u This appliance also has a "secondar y menu" allowing the user to: 1 Set the time shown on the display (DSP1).
44 Instructions f or the user 7.6.1 Modifying the sec ondary menu settin gs The secondar y menu appears th e first time the appliance is u sed or after a power black out, or can be accessed by keeping PT1 depressed f or 3 seconds with the ov en in OFF status (see point “7.
45 Instructions f or the user 7.7 Cooling fan system The appliance is equipped with a co oling system which comes into operation as soon as a cooki ng function or a cleaning cycle (Pyrolysis) star ts.
46 Instructions f or the user 8. USING THE PIZZA FUNCTION (ON SOME MODELS ONLY) This appliance is equipped with a function specially dev elop ed f or cooking pizza. This function is identified by the symbol on the oven functions knob . T o cook a pizza, proceed as descr ibed below .
47 Instructions f or the user 8.2 T o save energ y The pizza stone acts as a heat rese r voi r . This allows energy consumption to be reduced, especially in cookin g operations requirin g pre-heating or medium-long times. In these cases, si mply turn the thermostat to zero 10- 12 minutes bef ore the end of the cooking time.
48 Instructions f or the user 9. A CCESSORIES A V AILABLE The ov en is fitted with 4 runners f or placing tra ys and shelves at different heights. Shelf: useful to suppor t pan s containing the f ood for cooking. Tr a y g r i d : for placing on top of a tra y for cooking foods which ma y dr ip .
49 Instructions f or the user 10. RECOMMENDED COOKING T ABLES The ov en must be preheated before all cooking operations. Do not place the foods inside the oven until the degrees Centigrade symbol on the display stops flashing and the bee p has sounded to co nfir m that the set temperat ure has been reache d.
50 Instructions f or the user HOT AIR COOKING RUNNER P OSITION FROM THE BO TTOM TEMPERA TURE °C. TIME IN MINUTES PA S TA LASA GNE P AST A BAKES 2 2 210 - 230 210 - 230 45 - 50 25 - 30 MEA T ROAST VEA.
51 Instructions f or the user GRILLING RUNNER POSITION FR OM THE BO TTOM TIME IN MINUTES 1ST SIDE 2ND SIDE PORK CUTLET PORK FILLE T FILLET STEAK SLICED LI VER VEAL ESCALOPES HALF CHICKEN SA USAGE MEA .
52 Instructions f or the user 11. CLEANING AND MAINTENANCE Before carrying out any operations, disconnect the appliance from the electricity supply . Nev er use a jet of steam for cleaning the inside of the ov en.
53 Instructions f or the user 11.4 Cleaning the oven T o keep the oven in good condition, it must be cleaned regula rly , after allowing it to cool down. Remove all remov able par ts. • Clean the oven shelv es with hot water and non-abrasive detergents, rinse an d dr y .
54 Instructions f or the user • The oven should be operated at the maximum heat setting for 15/20 minutes after use of specific products, to b ur n off the residues left inside the o v en.
55 Instructions f or the user 11.5 Cleaning th e oven with sel f-cle aning liners (on some models only) The ov en is fitted with enamelled lin er s that are continuously self-cleaning. These liners simplify cle aning of the oven and ensure it continues to perf or m well ov er time.
56 Instructions f or the user 12. EXTRA ORDINAR Y MAINTENANCE Occasionally , the ov en will require min or ser vicing procedures or the replacement of par ts subject to wear and tear , such a s gaskets , light bulbs, etc. The specific operations fo r each proced ure of this kind are provided below .
57 Instructions f or the user 12.2 Remo ving the door 12.2.1 With type 1 mobile lever s With the door completely open, lift the lev ers A of the two hinges unti l they touch the hinges B and take hold of the two sides of the door 1) with both h ands close to the hin ges.
58 Instructions f or the user 12.4 Remo ving the inside glas s with the door cold The glass in the d oor should always be k ept thoroughly clean. Fo r easier cleaning, the door glazing can be full y remov ed by proceeding as describe d below . After opening the door and locking it in place as describe d in point “12.
59 Instructions f or the installer 13. INST ALLING THE APPLIANCE 13.1 Electrical connection: The nameplate with the technica l data, ser ial number and mar k is in a visible position on the ov en door surround. The nameplate must nev er be removed. The appliance must be connected to ear th in compliance with electrical system safety regulations.
60 Instructions f or the installer 13.2 P ositioning the o v en The appliance is designed for building- in to cabinets made from any heat- resistant mater ial. Comply with t he dimensions shown in figures 1 , 2 , and 3 . When installing und er worktops, comply with th e dimensions shown in figure 1 - 3 .
An important point after buying a device Smeg SC106ALU (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Smeg SC106ALU yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Smeg SC106ALU - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Smeg SC106ALU you will learn all the available features of the product, as well as information on its operation. The information that you get Smeg SC106ALU will certainly help you make a decision on the purchase.
If you already are a holder of Smeg SC106ALU, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Smeg SC106ALU.
However, one of the most important roles played by the user manual is to help in solving problems with Smeg SC106ALU. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Smeg SC106ALU along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
