Instruction/ maintenance manual of the product HA-318T SkyLink
Go to page of 2
1. INTRODUCTION In order for the sensor to communicate with the receiver properly , the sensor’s code must match with the receiver’s code. Code connectors 1 to 6 can be found by opening the battery cover and back cover of the receiver .
CUSTOMER SERVICE Email:support@skylinkhome.com (Reply within 24 hrs) http://www.skylinkhome.com P/N. 101A227-001 Rev .1 ©2003 SKYLINK GROUP When motion is detected in the monitored area, the sensor will send a signal to the receiver . It will beep and the corresponding zone red LED will flash for 15 seconds.
An important point after buying a device SkyLink HA-318T (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought SkyLink HA-318T yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data SkyLink HA-318T - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, SkyLink HA-318T you will learn all the available features of the product, as well as information on its operation. The information that you get SkyLink HA-318T will certainly help you make a decision on the purchase.
If you already are a holder of SkyLink HA-318T, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime SkyLink HA-318T.
However, one of the most important roles played by the user manual is to help in solving problems with SkyLink HA-318T. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device SkyLink HA-318T along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
