Instruction/ maintenance manual of the product SE 25M276 EU Siemens
Go to page of 28
.
.
en Index Safety instructions 4 . . . . . . . . . . . . . Getting to know your appliance 5 . . W ater softener 6 . . . . . . . . . . . . . . . . Filling the salt dispenser 6 . . . . . . . . Adding rinse aid 7 . . . . . . . . . . . . . . . Utensils 8 . .
en 4 Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier . Please dispose of packaging material properly . Installation Install and connect the appliance according to the installation and assembly instructions.
en 5 Children in the household If fitted, use the childproof lock. An exact description can be found in the back of the envelope. Do not allow children to play with or operate the appliance. Keep children away from detergents and rinse aid. These may cause chemical burns in the mouth, throat and eyes or asphyxiation.
en 6 W ater softener In order to rinse dishes and glasses satisfactorily , the dishwasher requires soft water , i.e. containing little or no lime, otherwise water stains will be left behind on crockery and glasses, etc. If the tap water exceeds a certain level of hardness, it must be softened, i.
en 7 The LOW SAL T indicator 8 on the front panel will light up initially but will extinguish again after a short period when the salt solution has become suf ficiently concentrated. When the control is set to , it is not necessary to fill up with salt as none will be consumed while the dishwasher is operating.
en 8 Adjusting the amount of rinse-aid The amount of rinse-aid added to the water can be varied by adjusting the stepless control. The rinse-aid control has been set to ”4” in the factory .
en 9 Loading the dishwasher Remove large food remnants. It is not necessary to rinse them of f under running water . When loading the dishwasher , ensure that D all utensils are secure and cannot fall over . D the openings of all receptacles are face down.
en 10 Shelf * * not on all models Lean tall glasses and those with long stems against the shelf – not against other items to be washed. Long items, serving cutlery , salad servers or knives should be placed on the shelf so that they do not obstruct the rotation of the spray arms.
en 1 1 T op basket with side levers (Rackmatic) Pull out the top basket. T o lower the basket, press in one lever and then the other situated on the left and right of the basket exterior , holding the basket firmly on the sides of the upper edge to prevent it from falling down.
en 12 Reduce costs! If your dishes are only moderately dirty , you may be able to use less detergent than recommended. Close the lid on the detergent compartment.
en 13 Note Optimum rinsing and drying results can be obtained by using standard detergents in conjunction with separate application of salt and rinse aid. Observance of the operating instructions or information on the packaging of the combined detergents determines their ef fectiveness.
en 14 Overview of programmes The max. possible number of programmes is illustrated in this overview . The corresponding programmes for your appliance can be found on the fascia. Cof fee, cake, milk, sausage, cold drinks, salads Soups, souf flés, potatoes, pastries, rice, eggs, fried food Delicate T ype of Dishes e.
en 15 Programme selection The most appropriate programme can be identified by comparing the type of crockery , cutlery , etc., as well as the amount and condition of food remains, with the details contained in the programme overview . Y ou will find the appropriate programme information in the introduction.
en 16 Keep pressing the timer programming button until the required time is displayed. T o delete the timer programming, keep pressing the button until is displayed. Y ou can change your programme selection at any time until the programme starts. End of programme The programme has ended when a figure appears in the numerical display 3 .
en 17 Additional functions * on some models additional functions 5 can be set with the buttons. Soaking * The soaking cycle runs before the main programme and must be selected before the programme starts. In this additional programme cooking utensils, e.
en 18 Inspect the filters for obstructions every time the dishwasher has been used. By unscrewing the filter cylinder , you can remove the filter system. Remove any food remnants and clean the filters under running water . Reassembly: Insert the filter system and screw down with the filter cylinder .
en 19 Pump * * on applicable models Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. The water is no longer pumped out of the dishwasher and it can be seen covering the filter .
en 20 The filter on the water supply hose is blocked. Switch of f the appliance and pull out the mains plug. T urn of f the tap. Then clean the filter which is situated at the connection of the supply hose. Finally , restore the power , turn on the tap and switch on the appliance.
en 21 ... with the dishes, cutlery , etc. Remnants of food are stuck to the dishes, cutlery , etc. Dishwasher was not loaded properly . Jets of water could not reach all parts of the dishes, etc. T oo many items in the rack. Items in the rack were touching each other .
en 22 Customer Service Please call your local service agent, if you are not able to resolve any problem yourself. The name of your nearest service agent is shown in the Customer Service address list.
en 23 Installation The dishwasher must be connected by a qualified technician to ensure correct operation. The specifications for supply , drainage and connected load must fulfil the required criteria as stated in the following paragraphs or in the installation instructions.
en 24 Disconnect the waste water and fresh water connections. Loosen the fastening screws under the worktop. If fitted, remove the base panel. Pull out the appliance, carefully pulling the hose behind. T ransporting the dishwasher Drain water from the dishwasher .
en 25 Disposal of the packaging Please dispose of the packaging material in an environmentally friendly manner . Keep children away from shipping carton and packaging components. Danger of suf focation from folding cartons and plastic film. D Corrugated cardboard consists mainly of wastepaper .
en 26 en Subjekt to modification.
40 Switch on the child-proof lock 41 Open the door with child-proof lock switched on 42 Switch of f the child-proof lock When the door is open, the child-proof lock of fers no protection.
.
An important point after buying a device Siemens SE 25M276 EU (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Siemens SE 25M276 EU yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Siemens SE 25M276 EU - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Siemens SE 25M276 EU you will learn all the available features of the product, as well as information on its operation. The information that you get Siemens SE 25M276 EU will certainly help you make a decision on the purchase.
If you already are a holder of Siemens SE 25M276 EU, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Siemens SE 25M276 EU.
However, one of the most important roles played by the user manual is to help in solving problems with Siemens SE 25M276 EU. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Siemens SE 25M276 EU along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
