Instruction/ maintenance manual of the product MH-1063 QSC Audio
Go to page of 8
*TD-000180-00* Cinema Mid-High Loudspeaker Sy stem User Manual MH-1063 10” (254mm) mid, 2.5” (63mm) compression driver MH-1075 10” (254mm) mid, 3.
2 Settings BI-AMP / TRI-AMP Operating Mode Selection Set the operating mode selector switch to BI-AMP or TRI-AMP , depending on your application setup. Mounting Attaching to Low Fre quency Enclosure The mid-high loudspeaker assembly attaches to the top of the QSC low frequency cabinet with three 5/16-18 bolts, 0.
3 Connections INPUT T erminals The MH-1063 and MH-1075 have barrier strip screw te rminals that accept up to #10 A W G (5.3mm 2 ) stranded loudspeaker wire. Observe proper polarity . Use the largest wire size and shortest wire length for the application.
4 Connections (continued) TRI-AMP mode connections- When the mode switch is set to TRI-AMP , connect the high frequency signal to the terminals marked “ INPUT HI + - ” and the mid frequency signal to the terminals marked “ INPUT MID + - ”.
5 MH-1063 Specifications (subject to change withou t notice) Freq. Range 180 - 15k (-6dB, full space) Nominal Coverage 90° horizontal X +20 to -30° vertical (50° total, adjustable mount provides for vertical plane adjustments.
6 MH-1075 Specifications (subj ect to change without notice Freq. Range 180 - 15k (-6dB, full space) Nominal Covera ge 90° horizontal X +20 to -30° vertical (50° total, adjus table mount provides for vertical plane adjustments.
7 MH-1075 SPL and Impedance vs. Frequency SPL (dB) Frequency (Hertz) Impedance (Ohms) Impedance SPL MH-1063 SPL and Impedance vs. Frequency SPL Impedance SPL (dB) Frequency (Hertz) Impedance (Ohms).
Warranty (USA only; ot her countries, see your dealer or distributor) Disclaimer QSC Audio Products, Inc. is not liable for any damage to amplifiers, or any other equipment that is caused by negligence or improper installation and/or use of this loudspeaker product.
An important point after buying a device QSC Audio MH-1063 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought QSC Audio MH-1063 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data QSC Audio MH-1063 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, QSC Audio MH-1063 you will learn all the available features of the product, as well as information on its operation. The information that you get QSC Audio MH-1063 will certainly help you make a decision on the purchase.
If you already are a holder of QSC Audio MH-1063, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime QSC Audio MH-1063.
However, one of the most important roles played by the user manual is to help in solving problems with QSC Audio MH-1063. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device QSC Audio MH-1063 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
