Instruction/ maintenance manual of the product PLCD65WXMU PYLE Audio
Go to page of 16
OWNER’S MANUAL Mobile Audio System • PLL Synthesizer Stereo Radio • CD Player/MP3 Player/WMA Player • Automatic Memory Storing • Full Detachable Panel • Preset Equalization • Electronic Shockpr oof (ESP) Function • USB Interface • Auxiliary Input Function • Remote Control PLCD65WXMU www .
2 CONTENTS Installation ...........................................3 T ake out screw befor e installation.........3 DIN Front-Mount (Method A) ................3 Installing the unit .................................3 Removing the unit .................
3 INST ALLA TION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly .
grounding of the unit. Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard. 10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel.
DIN REAR-MOUNT (Method B) If your vehicle is a Nissan, Toyota, follow these mounting instructions. Use the screw holes marked T (T oyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle.
USING THE DET ACHABLE FRONT P ANEL REMOVING THE FRONT P ANEL 1. Pr ess the release button ( ) on the front panel and pull of f the front panel. 2. Keep fr ont panel into the case. INST ALLING THE FRONT P ANEL T o install the front panel, insert the panel into the housing and make sure the panel is properly installed.
7 WIRING CONNECTION FRONT Lch SPEAKER GREEN GREEN/BLACK MEMORY BACK-UP (B+) MAIN UNIT Rch RED Lch WHITE AUX IN CABLE IGNITION SWITCH (ACC+) POWER ANTENNA RED GROUND (B – ) YELLOW BLACK BLUE RCA CABL.
8 OPERA TION LOCA TION OF KEYS 12 17 7 18 15 10 5 8 11 9 4 24 21 20 22 2 3 1 6 19 13 16 14 23.
9 OPERA TION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button (except button (7) and button (4)). When system is on, press POWER button (9) to turn off the unit. F ACEPLATE RELEASE Press button (7) to detach the removable faceplate.
10 OPERA TION CD OPERA TION • SWITCHING TO CD MODE If there is no CD inserted in the driver: Gently insert the CD with the printed side uppermost into the CD compartment until you feel some resistance. The CD is drawn into the driver automatically .
11 OPERA TION MP3 OPERA TION • SWITCHING TO CD (MP3) MODE If there is no MP3 disc inserted in the driver: Gently insert the MP3 disc with the printed side uppermost into the disc slot (5) until you feel some resistance. The MP3 disc is drawn into the driver automatically .
KEY Assigned IN Searching mode(T able 1) AUDIO KONB (ENCODER) & TUNE/TRACK UP/DOWN buttons: Searching file and dir ectory during Navigation. WMA OPERA TION The unit that can play the WMA disc and the operation is the same with MP3 operation described above.
OPERA TION in the device, the operation is the same with the MP3 operation described above. Note: • The main unit can only support the standard USB-memory disc which is approved by Micr osoft. • USB MP3 player is not a standard which means differ ent brand name or different models have their own standard.
14 REMOTE CONTROL HANDSET FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP (0) = Display Button (_, – , +, 0 For MP3/WMA Operation ) 3. SEL = Sound Mode Select Button (Character Shift Right For MP3/WMA Operation ) 4. VOL = V olume Up Button [Character Select (A, B ~ 8, 9, 0) For MP3/WMA Operation] 5.
15 SPECIFICATION GENERAL P o wer Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 160 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ± 10 dB - T reble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 50 W atts Current Drain : 15 Ampere (max.
88-C2007-02 TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition switch is If the power supply is not on.
An important point after buying a device PYLE Audio PLCD65WXMU (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought PYLE Audio PLCD65WXMU yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data PYLE Audio PLCD65WXMU - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, PYLE Audio PLCD65WXMU you will learn all the available features of the product, as well as information on its operation. The information that you get PYLE Audio PLCD65WXMU will certainly help you make a decision on the purchase.
If you already are a holder of PYLE Audio PLCD65WXMU, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime PYLE Audio PLCD65WXMU.
However, one of the most important roles played by the user manual is to help in solving problems with PYLE Audio PLCD65WXMU. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device PYLE Audio PLCD65WXMU along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
