Instruction/ maintenance manual of the product BVM200VS Poulan Pro
Go to page of 14
PoulanPRO ! Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner I'outil au detaillant.
t_1 iIWAI-ININB: This unit can be dangerous! Careless or improper zi ____.....A use can cause serious injury. 1 Read your operator's manual carefully until you completely understand and can follow all warnings and safety rules before operating the unit.
I® When using the vacuum attachment, the unit is designed to pick up dry material such as leaves, grass, small twigs, and bits of paper Do not vacuum stones, gravel, metal, broken glass, etc., to avoid severe dam- age to the impeller WARNING: Fire hazard.
• Move at _east 10 feet (3 meters) away from fuel and fueling site before starting engine. • Always store gasoline in a container ap- proved for flammable liquids. OPERATE YOUR UNIT SAFELY Ai_WARNING: Stop the engine before opening the vacuum inlet door.
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or b_ower tubes. The rotating blades can cause serious injury. Always disconnect the spark p_ug before performing maintenance or ac- cessing movable parts.
b_ower tubes. The rotating blades can cause serious injury 1. Insert the tip of a screwddver into the latch area of the vacuum inlet. Vacuum Inlet Cover 2. Gently tilt the handle of the screwddver to- ward the front of the unit to release the latch while pulling up on the vacuum inlet cover with your other hand.
KNOW YOUR BLOWER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT Compare the Jltustrations with your unit to famitJadze yourself with the location of the various controls and adjustments. Save this manual for future reference.
• To reduce noise _eveis, operate power blowers at the lowest possible throttle speed to do the job • Use rakes and brooms to loosen debds be- fore blowing. • In dusty conditions, slightly dampen sur- faces or use a mister attachment when wa- ter is available.
4 Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times. 5 As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE position. 6 Pull starter rope sharply until engine runs, but no more than 6 pulls.
Cleaning the air filter: 1. Clean the cover and the area around it to keep debds from falling into the carburetor chamber when the cover is removed NOTE: Move choke lever to RUN position before opening air fi_ter cover. 2. Open air filter cover by pushing button (see illustration) Remove air filter.
CARBURETOR ADJUSTMENT The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions: • Engine will not idle when the throttle is re- leased. Idle Speed Adjustment Allow engine to idle.
TROUBLESHOOTING TABLE _ WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit. TROUBLE CAUSE Engine will not 1. Engine flooded. start. 2. Fuel tank empty.
Poulan PRO, a division of Husqvarna Outdoor Products Inc., warrants to the odginal consumer purchaser that each new Foulan PRO brand gasoline tao_ or attachment is free from defects in material and wo.
of parts not made or approved by the orkjinaJ equipment manufacturer. You are responsible for presenting your small off-road engine to an Poulan PRO authorized repair center as soon as a problem exists. Warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.
An important point after buying a device Poulan Pro BVM200VS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Poulan Pro BVM200VS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Poulan Pro BVM200VS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Poulan Pro BVM200VS you will learn all the available features of the product, as well as information on its operation. The information that you get Poulan Pro BVM200VS will certainly help you make a decision on the purchase.
If you already are a holder of Poulan Pro BVM200VS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Poulan Pro BVM200VS.
However, one of the most important roles played by the user manual is to help in solving problems with Poulan Pro BVM200VS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Poulan Pro BVM200VS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
