Instruction/ maintenance manual of the product G1 Polar
Go to page of 8
Congratulations! Y ou are now the proud owner of a Polar G1 GPS sensor . Polar G1 provides speed and distance data in all outdoor sports using Global Positioning System (GPS) technology . The Polar G1 sensor determines your location by measuring continuously the distance between itself and at least four satellites.
Wearing Polar G1 Sensor 1. Push to open the clip (Picture 2). 2. Thread the armband loosely through the loops on the clip and fasten (Picture 3). Y ou can fasten the sensor on a belt or on the top of a backpack without the armband. 3. Position the armband round your upper arm and fasten (Picture 4).
Switching Power Mode Y ou can use the Polar G1 sensor in low or full power mode. The default mode is full power mode. By using the low power mode, you can increase battery life by up to 40 %. For maximum accuracy of speed and distance measurement, use full power mode.
Care and Maintenance The following instructions will help you fulfill guarantee obligations. • Wash the armband in a washing machine at 40°C / 104°F . Use a washing pouch. Do not soak, nor use detergent with bleach or fabric softener . Do not dry-clean.
• Strong electromagnetic signals can cause erratic readings. Electromagnetic disturbances may occur near high-voltage power lines, traffic lights, overhead lines of electric railways, electric bus lines or trams, televisions, car motors, bike computers, some motor driven training equipment, cellular phones, or at electric security gates.
Limited International Polar Guarantee • This limited Polar international guarantee is issued by Polar Electro Inc. for the consumers who have purchased this product in the USA or Canada. This limited Polar international guarantee is issued by Polar Electro Oy for the consumers who have purchased this product in other countries.
This Category II radiocommunication device complies with Industry Canada Standard RSS-310. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1).
Disclaimer The material in this manual is for informational purposes only . The products it describes are subject to change without prior notice, due to the manufacturer’s continuous development program.
An important point after buying a device Polar G1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Polar G1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Polar G1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Polar G1 you will learn all the available features of the product, as well as information on its operation. The information that you get Polar G1 will certainly help you make a decision on the purchase.
If you already are a holder of Polar G1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Polar G1.
However, one of the most important roles played by the user manual is to help in solving problems with Polar G1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Polar G1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
