Instruction/ maintenance manual of the product PLDE36 Pentair
Go to page of 24
System 2 TM Modular DE F ilter O W N E R’ S M A N U A L INST ALLA TION, OPERA TION & P ARTS MODELS PLDE36 PLDE48 Sta-Rite P ool/Spa Gr oup 293 Wright Street, Delavan, WI 53115 International: 262-728-5551, FAX: 262-728-7550 www.starite.com Union City, TN • Delavan, WI • Mississauga, Ont.
T able of Contents Safety Instructions .........................................................2 General Information ......................................................3 Specifications ..............................................................
3 GENERAL INFORMA TION • Clean a new pool as well as possible before filling pool and operating filter . Excess dirt and large particles of foreign matter in the system can cause serious damage to the filter and pump.
4 Inlet Outlet 7-13/16 (198) 9-3/16 (233) 18.5 (470) 18.5 (470) 36 (914) 45.25 (1 150) 0 5 10 15 20 20 40 60 80 100 Pressure drop (PSI) Flow (GPM) PLDE36 PLDE48 SPECIFIC A TIONS FIGURE 1A – Dimensions in inches (mm) T able 1 - Recommended DE Manufacturers Johns Manville Celite 545™ GREFCO, Inc.
5 INST ALLA TION Installation of filter should only be done b y qualified, li- censed personnel. Filter Assembl y Filter mount must: • Be solid, level, rigid, vibration free, and provide for ad- equate drainage. • Be as close to pool as possible to reduce pressure loss from pipe friction.
6 valve, close the valve. NO TICE: Leaking around the Posi-Lok™ ring may indi- cate that the ring is not fully locked. In this case, pro- ceed as follows: a. Stop the pump, close the isolation valves, and open the air release valve to release any pressure within the filter .
7 5. Remove Posi-Lok™ ring as follows: a. Press safety latch (below the ring) toward the tank to release it (see Figure 4). b. Hold latch in the release position and rotate ring COUNTERCLOCKWISE to remove. If ring is difficult to turn, tap gently with a rubber mallet to overcome initial resistance.
MODULE CLEANING PRO- CEDURE Risk of chemical burns. Do not attempt to acid clean the filter or module. If the filter re- quires acid cleaning, have a trained pool professional do the job. Follow all steps in the “Disassembly” section of this manual.
9 SYSTEM INSPECTION Gener al: W ash the outside of the filter with a mild detergent and water . Rinse off with a hose. NO TICE: DO NOT use solvents to clean the filter; sol- vents may damage plastic components in the system. NO TICE: Open the air bleed valve and bleed all air from the filter each time the pump is stopped and restarted.
10 3 6 4 5 7 8 11 10 9 1 6 A 2 4 3 2 O P E N C L O S E PLDE 36 PLDE 48 12 Key Part No. Description Qty. PLDE36 PLDE48 1 Posi-Lok™ Ring 1 27001-0054S 27001-0054S 2 Air Release Valve with O-ring 1 250.
11 1. Short Cycle T ime: NOTICE: Cycle Time will vary with each installation and be- tween different areas of the country. The following causes and remedies are for cycle times shorter than normal for your area. A. Chlorine residual too low; maintain proper residual (con- sult pool professional for recommendation).
CREATE A RECORD OF YOUR WARRANTY AT STA-RITE: • Complete a warranty registration at www.staritepool.com by clicking on “Register Products” and selecting Sta-Rite Pool OR • Complete bottom portion completely and mail within 10 days of installation to Sta-Rite, Attn.
F iltr o modular de tierr a de diatomeas “System 2 TM” MANUAL DEL PROPIET ARIO INST ALACIÓN, OPERACIÓN Y REPUEST OS MODELOS PLDE36 PLDE48 Sta-Rite P ool/Spa Group 293 Wright Street, Delavan, WI 53115 Internacional: 262-728-5551, FAX: 262-728-7550 www.
Índice Instrucciones de seguridad ............................................2 Información general ......................................................3 Especificaciones ............................................................4 Instalación .
3 INFORMA CIÓN GENERAL • Limpie una piscina nueva a fondo antes de llenarla y hacer funcionar el filtro. El exceso de suciedad y de partículas de materias extrañas grandes en el sistema puede provocar daños graves en el filtro y en la bomba.
4 Inlet Outlet 7-13/16 (198) 9-3/16 (233) 18.5 (470) 18.5 (470) 36 (914) 45.25 (1 150) 0 5 10 15 20 20 40 60 80 100 Pressure drop (PSI) Flow (GPM) PLDE36 PLDE48 ESPECIFIC ACIONES FIGURA 1A – Dimensiones en pulgadas (mm) Cuadro 1 - F abricantes de tierra de diatomeas recomendados Johns Manville Celite 545™ GREFCO, Inc.
5 INST ALA CIÓN La instalación del filtro debe ser realizada sólo por personas calificadas y competentes. Ensamblaje del filtro La instalación del filtro debe: • Ser firme, nivelada, rígida, sin vibraciones y con un drenaje adecuado.
6 6. Cuando salga un chorro firme de agua de la válvula de desa- hogo de aire, cierre la válvula. AVISO: Fugas alrededor del aro Posi-Lok TM pueden indicar que el aro no está totalmente trabado.
7 5. Saque el aro Posi-Lok TM de la siguiente manera: a. Oprima el pasador de seguridad (debajo del aro) hacia el tanque para aflojarlo (consulte la Figura 4). b. Mantenga el pasador en la posición soltada y gire el aro HACIA LA IZQUIERDA para sacarlo.
PROCEDIMIENT O DE LIMPIEZA DEL MÓDULO Riesgo de quemaduras de índole química. NO trate de limpiar el filtro o el módulo con ácido. Si el filtro requiere limpieza con ácido, contrate a un profesional capacitado para piscinas para realizar ese trabajo.
9 INSPECCIÓN DEL SIS- TEMA Gener al: Lave el exterior del filtro con un detergente suave y agua. Enjuague a manguera. AVISO: NO use solventes para limpiar el filtro, ya que estos pueden dañar los componentes de plástico en el sistema.
10 3 6 4 5 7 8 11 10 9 1 6 A 2 4 3 2 O P E N C L O S E PLDE 36 PLDE 48 12 Clave No. Descripción Cant. PLDE36 PLDE48 1 Aro Posi-Lok TM 1 27001-0054S 27001-0054S 2 Válvula de desahogo de aire con aro .
11 1. T iempo de ciclo corto: AVISO: El tiempo de ciclo varía con cada instalación y entre difer- entes áreas del país. Las siguientes causas y soluciones son para tiempos de ciclo inferiores a los normales para su área. A. Cloro residual demasiado bajo; mantenga el residuo adecuado (obtenga las recomendaciones de un profesional de piscinas).
PARA CREAR UN REGISTRO DE SU GARANTÍA CON STA-RITE: • Llene un registro de garantía en www.staritepool.com pulsando en “Registro de Productos” y seleccionando Albercas Sta-Rite O • Llene la .
An important point after buying a device Pentair PLDE36 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pentair PLDE36 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pentair PLDE36 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pentair PLDE36 you will learn all the available features of the product, as well as information on its operation. The information that you get Pentair PLDE36 will certainly help you make a decision on the purchase.
If you already are a holder of Pentair PLDE36, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pentair PLDE36.
However, one of the most important roles played by the user manual is to help in solving problems with Pentair PLDE36. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pentair PLDE36 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
