Instruction/ maintenance manual of the product C2429M Pelco
Go to page of 16
BB5HD Series Heavy-Duty Spectra ® Back Box Installation Manual C2429M (3/01) P elco • 3500 P elco Wa y • Clovis , CA 93612-5699 USA • www .pelco .
2 Pelco Installation Manual C2429M (3/01) CONTENTS IMPORT ANT SAFEGUARDS AND WARNINGS ......................................................................................................... 3 DESCRIPTION .............................................
Pelco Installation Manual C2429M (3/01) 3 IMPOR T ANT SAFEGUARDS AND W ARNINGS Prior to installation and use of this product, the following W ARNINGS should be observed. CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes.
4 Pelco Installation Manual C2429M (3/01) DESCRIPTION The Heavy-duty Spectra is perf ect for installations where structural integ r ity and v andalism are a pr iority . The system f eatures barrel ke y locks , heavy-duty construction and a thick acr ylic low er dome.
Pelco Installation Manual C2429M (3/01) 5 b. Tu rn the thumbscrew and open the hinged door to the back bo x. Pull wiring into the back bo x through the conduit fitting. Ref er to T ab les A and B in the Appendix for wiring distances. 00535 c. Compress the spring clips on the back box and push it through the hole, until the clips spring back.
6 Pelco Installation Manual C2429M (3/01) STEP 4 - WIRE CIRCUIT BOARD Attach the wiring to the circuit board inside the back box. When finished, close the door to the back bo x and turn on the power . The red LED will light. IMPORT ANT : If the LED does not light, refer to the T rouble- shooting section .
Pelco Installation Manual C2429M (3/01) 7 INST ALLA TION PENDANT MODELS STEP 1 - MOUNT AND INST ALL THE BACK BOX NOTE: If installing outdoors make sure the installation is properly sealed to keep moisture out. a. Install the mount for the pendant dome.
8 Pelco Installation Manual C2429M (3/01) STEP 3 - INST ALL DOME DRIVE TO USE YOUR DOME, REFER TO THE OPERA TION AND PROGRAMMING MANUAL. b. Line up the green and red tabs with the green and red labels. Push in on the tabs. Insert the side with the green tab, then the side with red tab.
Pelco Installation Manual C2429M (3/01) 9 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Unit does not operate. The controller is not communicating with the Spectra unit. Fan does not operate. Ve r tical roll on monitor when switching between cameras.
10 Pelco Installation Manual C2429M (3/01) APPENDIX Ta b le A. Video Coaxial Cable Wir ing Distances Cable T ype* Maximum Distance RG59/U 750 ft (229 m) RG6/U 1,000 ft (305 m) RG11/U 1,500 ft (457 m) * Minimum cable requirements: 75 ohms impedance. All-copper center conductor .
Pelco Installation Manual C2429M (3/01) 11 Ta b le D. Switch Settings f or SW2 – P-T ype Control NO TE: F or Coaxitron controls, SW2 is not used; set all s witches OFF .
12 Pelco Installation Manual C2429M (3/01) Ta b le E. Switch Settings for SW2 – D-T ype Control (continued) (Continued on next page) Receiver Switch Setting Address SW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2.
Pelco Installation Manual C2429M (3/01) 13 Ta b le E. Switch Settings for SW2 – D-T ype Control (continued) Receiver Switch Setting Address SW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2-6 SW2-7 SW2-8 161 ON OFF.
14 Pelco Installation Manual C2429M (3/01) SPECIFICA TIONS MECHANICAL Construction Back box: Aluminum Dome drive: Aluminum, ABS plastic Lower dome: Acrylic Cable Entry In-Ceiling: .
Pelco Installation Manual C2429M (3/01) 15 GENERAL Environment In-Ceiling: Indoor only Pendant: Indoor/outdoor Operating Range In-Ceiling: 32 to 140 ° F (0 to 60 ° C) intermittent operation; 32 to 1.
16 Pelco Installation Manual C2429M (3/01) REVISION HISTOR Y Manual # Date Comments C2429M 3/01 Original version. P elco, the P elco logo, Camclosure, Esprit, Gene x, Legacy , and Spectra are registered trademarks of P elco. Endura and ExSite are trademarks of P elco.
An important point after buying a device Pelco C2429M (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pelco C2429M yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pelco C2429M - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pelco C2429M you will learn all the available features of the product, as well as information on its operation. The information that you get Pelco C2429M will certainly help you make a decision on the purchase.
If you already are a holder of Pelco C2429M, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pelco C2429M.
However, one of the most important roles played by the user manual is to help in solving problems with Pelco C2429M. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pelco C2429M along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
