Instruction/ maintenance manual of the product Ultra Plus Peavey
Go to page of 20
F3 I.
A Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Ultra’” Plus Features l All-tube design l Four 12AX7 preamp tubes l Four 6L6GC output tubes l 120 watts RMS @ 4,8, or 16 ohms l Three switchable channels l Master Reverb l Low-level effects loop l.
RESONANCE SWITCH (3) Used to fine tune the low frequency range of the speaker enclosure by varying the damping factor of the amplifier between three presets. OUTPUT SWITCH (4) Allows selection of power amp output to be selected from full power (120 watts) to half power (60 watts output).
VOLUME (21) Controls the overall volume level of the Clean channel. LOW GAIN INPUT (22) Provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the High Gain input. If both inputs are used simultaneously, the output levels are the same (both are low gain).
SPECIFICATIONS POWER AMPLIFIER SECTION Four 6L6GCs with 12AX7 driver Rated Power & Load: 120 W RMS into 16, 8, or 4 ohms Power @ Clipping: (typically @ 5% THD, 1 kHz, 120 VAC line) 130 W RMS into .
.
Tone Settings A’ A our I Adtust for Preference I ! I Adjust for Preference IN I Select for Preference METAL CLEAN MILD DISTORTION A A I Adjust for Preference OUT’ I I ‘OUT’ Adjust for Preference I A !@ .
Consulte 10s diagramas de1 panel delantero en la seccih de inglh de este manual. Ultra’” Plus Caracteristicas l Diseno a base de tubos exclusivamente Canal Clean (puro) l Cuatro tubos de preamp de.
OUTPUT SWITCH (Conmutador de salida) (4) Permite seleccionar la potencia de salida del amplificador en una gama que va desde potencia tonal (120 watts) hasta potencia media (60 watts de salida). POWER LED (LED indicador de corriente) (5) Se ilumina cuando el amplificador recibe corriente alterna.
VOLUME (El volumen) (21) Controla el nivel de volumen del canal “clean”. LOW GAIN INPUT (Entrada de baja ganancia) (22) Se suministra para instrumentos que tienen una salida extremadamente alta, la cual puede causar la sobrecarga (distorsion) de la entrada de alta ganancia.
Veuillez-vous refkrer au “front panel art” situ6 dans la section en langue anglaise de ce manuel. Ultra’r” Plus Caractbristiques l Conception entihrement tubulaire Canal Clean l Prkamplificate.
POWER LED (DEL temoin de mise sous tension) (5) S’allume lorsque I’ampli recoit I’alimentation CA. STATUS LED (DEL temoin) (6) S’allume lorsque I’ampli est en mode d’attente << Standby )’ pour indiquer que I’amplificateur test pas op&ationnel.
LOW GAIN INPUT (Entree faible gain) (22) Cette prise accepte les instruments a tres haut niveau de sortie qui causeraient de la saturation (distorsion) sur I’entree << High Gain >>. Si les deux entrees sont utilisees simultanement, les niveaux son alors equivalents (cc Low Gain >>).
Siehe Diagramm der Frontplatte im englischen Teil des Handbuchs. Ultra’” Plus Technische Daten l Riihrensystem Clean Channel (Kanal fiir Klarton) l Vier 12AX7 Eingangsrohren l Vier 6L6GC Ausgangsr.
STATUS LED (Zustand kontrollampe) (6) Leuchtet auf, wenn der verst rker aut standby“ steht und zeight an, daB er nicht arbeitet. MASTER VOLUME (Hauptlautstiirke) (7) Regelt die Gesamtlautstarke des Get-&s.
Riickplatte: BESCHREIBUNG DER RUCKPLATTE IMPEDANCE SELECTOR SWITCH (Impedanz Wahlschalter) (24) Hiermit wird die entsprechende lautsprecher-impedanz eingestellt. Bei der verwendung von z.B. zwei lautsprechern gleicher impedanz sollte der schalter auf die halfte des werts eingestellt werden.
THIS LIMITED WARRANTY VALID ONLY WHEN PURCHASED AND REGISTERED IN THE UNITED STATES OR CANADA. ALL EXPORTED PRODUCTS ARE SUBJECT TO WARRANTY AND SERVICES TO BE SPECIFIED AND PROVIDED BY THE AUTHORIZED DISTRIBUTOR FOR EACH COUNTRY. Ces clauses de garantie ne sont vaiables qu’aux Etats-Unis et au Canada.
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. Read all safety and operating instructions before using this product.
Features and specifications subject to change without notice. A Peavey Electronics Corporation 711 A Street / Meridian, MS 39301 / U.S.A. / (601) 483-5365 / Fax 486-l 278 01996 #80300294 Printed in U.
An important point after buying a device Peavey Ultra Plus (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Peavey Ultra Plus yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Peavey Ultra Plus - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Peavey Ultra Plus you will learn all the available features of the product, as well as information on its operation. The information that you get Peavey Ultra Plus will certainly help you make a decision on the purchase.
If you already are a holder of Peavey Ultra Plus, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Peavey Ultra Plus.
However, one of the most important roles played by the user manual is to help in solving problems with Peavey Ultra Plus. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Peavey Ultra Plus along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
