Instruction/ maintenance manual of the product SWI-JACK PAC
Go to page of 8
1 06-08-09 SWI-JACK Universal Steering Wheel Control Interface Before Y ou Start A. Is this product compatible with the vehicle? • See application guide (separate sheet) for listing of vehicles and connection information. If not, please visit http://www .
2 SWI-JACK Wiring Connections Step 1. Connect the BLACK wire to ground (-). V erication: Wire or location registers a constant (-) when probed. Step 2. Connect the RED wire to switched +12V . V erication: Wire reg- isters +12V when the ignition key is turned to the ACC or ON posi- tions.
3 06-08-09 Step 5. Refer to The V ehicle Application Guide . Note the INTERF ACE V ersion Number next to the selected vehicle. Fill in the information below for quick reference. The Radio Select Switch must be set BEFORE programming the INTERF ACE version number .
4 Step 18. Press and hold program- ming/mode button on SWI-JACK. LED will light. Step 19. Release programming/ mode button. SWI-JACK SWI-JACK SWI-JACK Y ou only need to press the programming/mode button once to program all the buttons. If you press this button again after the interface is programmed, it will erase all previous learned buttons.
5 06-08-09 Programming the SWI-JACK to Control the Head Unit (cont.) The SWI-JACK must be programmed in the specic order shown in the chart below . If a function is not needed, it may be skipped by pressing the Program/Mode button 1 time per function in its place.
6 SWI-JACK SWI-JACK Step 22. Release the button. The LED will turn on back on. Skip to Step 24. Step 24. If you need to program more buttons, repeat step 20 for each additional audio function on the steering wheel. Once programming is completed, wait 7 seconds.
7 06-08-09 T esting the SWI-JACK (For V ersion #4 only) T est each Heater function of the steering wheel controls. The TEMP and F AN should work properly . When testing the audio controls, the left LED on the SWI-JACK will ash indicating it is sending a command.
8 T roubleshooting Guide Working on a new or unlisted vehicle? We are always looking for new vehicle information. If you’ve successfully completed the installation on a vehicle with steering wheel controls, and the vehicle is not listed in these instructions or on our Website, contact us at techsupport@pac-audio.
An important point after buying a device PAC SWI-JACK (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought PAC SWI-JACK yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data PAC SWI-JACK - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, PAC SWI-JACK you will learn all the available features of the product, as well as information on its operation. The information that you get PAC SWI-JACK will certainly help you make a decision on the purchase.
If you already are a holder of PAC SWI-JACK, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime PAC SWI-JACK.
However, one of the most important roles played by the user manual is to help in solving problems with PAC SWI-JACK. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device PAC SWI-JACK along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
