Instruction/ maintenance manual of the product XL2800HAY Oreck
Go to page of 8
HIGH SPEED UPRIGHT V ACUUM CLEANER WITH ® CLEANING SYSTEM SIMPL Y AMAZING ® U SER ’ S G UIDE •IMPOR T ANT• SA VE THIS BOOKLET! Includes: • Safety W arnings • W arranty • Operating Instru.
2 T able of C ontents BEFORE OPERA TING CLEANER, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULL Y . Important Safety Instructions . . . . . . . page 2 Maintenance and Customer Ser vice, W arranty , Accessories, Assembly . . . . page 3 General Infor mation, T o Replace Filter Dust Bag, Bag Installation .
A ssembly T o assist you in identifying components of your vacuum, the parts have been numbered as follows : 1 Handle section, upper 2 T ube, lower 3 Power head 4 Outer bag 5 Paper filter dust bag 6 P.
4 fig. 1 Befor e assembling appliance, remove two scr ews from the connector assembly . Remove cardboard insert by pulling upward. fig. 2 With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the connector assembly .
5 O per ating I nstructions T o Operate Make sure the disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet. Choose from the low and high speed settings by pressing the ON/LOW (l) ON/HIGH (ll) - OFF (O) switch on handle assembly when ready to operate.
SA VE SERVICE CALLS...CHECK THESE FIRST : • Is the disposable filter dust bag full? • Are pores of filter dust bag clogged with powder or fine dust? • Is anything clogging the revolving brush, l.
7 W ARNING: Unplug cord from electrical outlet before servicing. H o w to R eplace a W orn B elt Remove the replacement belt from the storage channel. Remove the door by removing the hold down screw located on side of power head. Slide the door for ward by pr ying open with a screwdriver or coin.
B ulb R eplacement • Remove lamp housing by removing two (2) screws in the the top of the lamp housing. • Pull burned out bulb from holder and replace with new bulb. Use only Oreck replacement parts. • Replace lamp housing by r eplacing two screws in the top of the lamp housing.
An important point after buying a device Oreck XL2800HAY (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Oreck XL2800HAY yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Oreck XL2800HAY - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Oreck XL2800HAY you will learn all the available features of the product, as well as information on its operation. The information that you get Oreck XL2800HAY will certainly help you make a decision on the purchase.
If you already are a holder of Oreck XL2800HAY, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Oreck XL2800HAY.
However, one of the most important roles played by the user manual is to help in solving problems with Oreck XL2800HAY. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Oreck XL2800HAY along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
