Instruction/ maintenance manual of the product NZ26 Napoleon Fireplaces
Go to page of 20
W415-0156 / A / 04.09.03 1 INST ALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER. Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031 www .napoleonfireplaces.com • ask@napoleon.
W415-0156 / A / 04.09.03 2 Congratulations on the purchase of your Napoleon hi-tech, high efficiency solid fuel burning fireplace! It has been extensively tested in Canadian and American laboratories .
W415-0156 / A / 04.09.03 3 NAPOLEON wood fireplaces are manufactured under the strict Standard of the World Recognized ISO 9001 : 2000 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained craftsmen who take great pride in their work.
W415-0156 / A / 04.09.03 4 CALIFORNIA PROP 65 WARNING: CALIFORNIA PROP 65 WARNING: CALIFORNIA PROP 65 WARNING: CALIFORNIA PROP 65 WARNING: CALIFORNIA PROP 65 WARNING: Use of this product may produce s.
W415-0156 / A / 04.09.03 5 For a basic hi-efficiency fireplace, blowers are not needed, how- ever , they are recommended for extra heat output and efficient air circulation. This can be especially important if the fireplace is to be used as a major source of heat.
W415-0156 / A / 04.09.03 6 Do not build shelves or cupboards into the area abo v e the fi re place. While the fireplace can be installed directly on the floor , a non-combustible hearth extension is required in front of the fireplace, that must not be built higher than the bottom of the fireplace to avoid air flow blockage.
W415-0156 / A / 04.09.03 7 Mantle clearance can vary ac- cording to the mantle depth. An acceptable 16" x 50" non-combustible (ie: brick, stone or ceramic tile) hearth extension must be installed.
W415-0156 / A / 04.09.03 8 FIGURE 1 1 - 4 ELBOWS FIGURE 10 - 2 ELBOWS FIGURE 9 - STRAIGHT UP No Off-Set. Minimum overall chim- ney height is 1 1 feet. Single off-set with two 15°, 30° or 45° elbows. Minimum overall chimney height is 1 1 feet. Double off-set with four 15°, 30° or 45° elbows.
W415-0156 / A / 04.09.03 9 1. Move the fireplace into position. Try to center the ex- haust flue of the fireplace, midpoint between two joists to prevent having to cut them.
W415-0156 / A / 04.09.03 10 FLUE TILE SUPPORT FOR A MASONRY FIREPLACE HI-TEMP GASKET FIREPLACE TOP ANCHOR PLA TE HI-TEMP GASKET FIREPLACE TOP For a masonry fireplace us e a flue tile support. For a pre- fabricated chimney use an anchor plate. In no case is the masonry enclosure to be sup- ported by the NZ26 fire- place .
W415-0156 / A / 04.09.03 11 Insert the left baffle, then the left top firebrick. Repeat using the right baffle and brick. The baffles are made of a brittle material. Care must be taken not to bend or force them. Replace the three front tubes. Position the center edges of both baffles and bricks until they lie snugly together .
W415-0156 / A / 04.09.03 12 INST ALLA TION TO BE DONE BY A QUALIFIED IN- ST ALLER and must be electrically connected and grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRI- CAL CODE in Canada or the ANSI/NFP A 70 NA TIONAL ELECTRICAL CODE in the United S tates.
.
W415-0156 / A / 04.09.03 14 For maximum efficiency , when the fireplace is thoroughly hot, load it fully to the top of the door opening and burn at a medium low setting. The bricks will be nearly all white and the glass mostly clear . The whiteness of the bricks and the cleanness of the glass are good indicators of your operat- ing efficiency .
W415-0156 / A / 04.09.03 15 A bed of ashes approximately 1 inch deep should be left on the firebox bottom to help maintain a hot charcoal bed. When the fire has burned down and cooled, remove any excess ashes. T o use your ash pan, pull the ash dump handle forward to an open position.
W415-0156 / A / 04.09.03 16 # P ART NO . DESCRIPTION 1 W300-0004 DOOR GLASS ONL Y 2 W562-0010 DOOR GASKET 3 W562-0016 GLASS GASKET 4 W325-0007 LARGE SPRING HANDLE 5 W325-0002 SMALL SPRING HANDLE 6 W01.
W415-0156 / A / 04.09.03 17.
W415-0156 / A / 04.09.03 18 Build your fire on the floor of the firebox and be- hind the log retainer only . Do not block or restrict the hot air outlets or air inlets . This will cause the fi r eplace to ov erheat. Keep fires away from the door . DOs: 1.
W415-0156 / A / 04.09.03 19 W olf Steel Fir eplace Ser vice Histor y This fireplace must be serviced annually depending on usage. Date Service T echnician Name Service Performed Special Concerns Deale.
W415-0156 / A / 04.09.03 20 NO TES.
An important point after buying a device Napoleon Fireplaces NZ26 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Napoleon Fireplaces NZ26 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Napoleon Fireplaces NZ26 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Napoleon Fireplaces NZ26 you will learn all the available features of the product, as well as information on its operation. The information that you get Napoleon Fireplaces NZ26 will certainly help you make a decision on the purchase.
If you already are a holder of Napoleon Fireplaces NZ26, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Napoleon Fireplaces NZ26.
However, one of the most important roles played by the user manual is to help in solving problems with Napoleon Fireplaces NZ26. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Napoleon Fireplaces NZ26 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
