Instruction/ maintenance manual of the product TA4501 MTX Audio
Go to page of 5
T A4501 Owner’ s Manual Introduction Thank you for choosing MTX to help reach the ultimate goal with your vehicle. Adding MTX amplifiers and matching MTX speakers and subwoofers with StreetWires connections will put you in a better position to hear , feel, and experience all of the music the artist intended.
5. Gain Control – This feature is used to fine-tune the input sensitivity of the amplifier to the source unit’ s output level. 6. Low-Pass 40Hz-200Hz V ariable X-over with 24dB per octave Slope – This control allows the user to choose the exact low-pass frequency range the amplifier will play for the best possible performance.
Connections 1. Bi-Level Inputs (Low/High Level Input) with Smart Engage™ – Both a low and high level signal can be used. Be sure to lay the signal wire away from all power cables and vehicle computers. Use high quality twisted pair interconnect cables to decrease the possibility of radiated noise entering the system.
Note: When numerous amplifiers are used in the same system, look into using a relay with a separate power wire connected to an alternative power source to take the strain off the source unit. Normal source units can only keep a constant 12 volts to 2 or possibly 3 amps.
5. Remote Subwoofer Level Control (Remote Gain) – Let’ s say the amplifier’ s gain is set at halfway , when the remote subwoofer level control is plugged in, you now have external control of the gain from zero to halfway . The installation of this level control is NOT necessary to get full power from the amplifier .
An important point after buying a device MTX Audio TA4501 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought MTX Audio TA4501 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data MTX Audio TA4501 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, MTX Audio TA4501 you will learn all the available features of the product, as well as information on its operation. The information that you get MTX Audio TA4501 will certainly help you make a decision on the purchase.
If you already are a holder of MTX Audio TA4501, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime MTX Audio TA4501.
However, one of the most important roles played by the user manual is to help in solving problems with MTX Audio TA4501. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device MTX Audio TA4501 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
