Instruction/ maintenance manual of the product TA3404 MTX Audio
Go to page of 5
T A3404 Owner s Manual Introduction Thank you for choosing MTX to help reach your ultimate goal with your vehicle. Adding MTX amplifiers and matching MTX speakers and subwoofers with StreetWires connections will put you in a better position to hear , feel and experience all of the music the artist intended you to hear .
4. Input Sensitivity –The Input Sensitivity switch is used to set the proper input voltage range: X1 POSITION: 100mV – 1V (T ypically for RCA Input) X10 POSITION: 1V – 10V (T ypically for Speaker Level Input) 5.
Connections 1. Bi-Level Inputs (Low/High Level Input) with Smart Engage – Both a low and high-level signal can be used. Be sure to lay the signal wire away from all power cables and vehicle computers. Use high quality twisted pair interconnect cables to decrease the possibility of radiated noise entering the system.
2. GND: This is the ground connection for the amplifier and must be connected directly to the metal chassis of the vehicle for the amplifier to operate properly . A properly grounded amplifier can be run harder and longer then a poorly grounded amplifier .
• Setting For Components and Separates: First enable the electronic crossover by selecting the “ON” position of the X-OVER switch, then select the “H-P ASS” (High pass) position on the L-P ASS/H-P ASS switch. By selecting this you are giving the speakers 85Hz – 20kHz.
An important point after buying a device MTX Audio TA3404 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought MTX Audio TA3404 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data MTX Audio TA3404 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, MTX Audio TA3404 you will learn all the available features of the product, as well as information on its operation. The information that you get MTX Audio TA3404 will certainly help you make a decision on the purchase.
If you already are a holder of MTX Audio TA3404, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime MTX Audio TA3404.
However, one of the most important roles played by the user manual is to help in solving problems with MTX Audio TA3404. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device MTX Audio TA3404 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
