Instruction/ maintenance manual of the product DA 7090 W Aura Miele
Go to page of 28
Operating and installation instructions Cooker hood DA 7090 W To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
Caring for the environment ..........................................3 Warning and Safety instructions .....................................4 Guide to the appliance .............................................8 Mode of operation .....................
Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and should be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children.
This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time.
Technical safety ~ Before installation, check the cooker hood for visible signs of damage. Under no circumstances should you install or use a damaged appliance.
~ This appliance must not be used in a non-stationary location (e.g. on a ship). ~ In areas which may be subject to infestation by cockroaches or other vermin, pay particular attention to keeping the appliance and its surroundings in a clean condition at all times.
~ Do not use the cooker hood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. ~ The filters should be regularly cleaned or changed as appropriate. Saturated filters are a fire hazard.
Guide to the appliance 8.
a Canopy b Holders for the charcoal filters c Grease filters d Controls The symbols act as sensors. Touch the sensors to select the function you require.
The cooker hood works with air recirculation. The air is drawn in and cleaned first by the grease filters and then by two charcoal filters . The cleaned air is then recirculated back into the kitchen through the grilles in the top of the cooker hood.
Con | ctivity This cooker hood is communication enabled. Communication module XKM 2000 DA a , available as an optional extra, enables the operation of the cooker hood to be automatically controlled by the operating status of a Miele electric hob with onset controls.
To switch the fan on s ^ Touch the On/Off sensor s . The fan will come on at power level 2 . The On/Off sensor s and the 2 sensor will light up. To select a power level Depending on the intensity of the cooking vapours, levels 1 to 3 are usually sufficient for normal cooking.
Run-on option "5 m 15" It is advisable to leave the fan running for a few minutes after cooking has finished to neutralise any lingering odours in the air.
Operating hours counter l| The number of hours the appliance has been in operation is stored in memory. The operating hours counters tell you when the grease filters or charcoal filters need to be cleaned or replaced.
One or more of sensors 1 to 4 will flash. The number of flashing sensors indicates the percentage of the operating time which has already been used up. Sensor 1 =2 5 % Sensors 1 and 2 =5 0 % Sensors 1 to 3 =7 5 % Sensors 1 to 4 = 100 % ^ When you take your finger off the Grease filter sensor l , the current fan setting will show.
^ Confirm the selection by touching the Charcoal filter sensor | . All the sensors will go out. If you do not confirm within 4 minutes, the cooker hood will automatically revert to the original setting.
A range of Miele branded cleaning and conditioning products is available to order from Miele (see back page for contact details) or from www.miele-shop.com. , Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply.
Cleaning the grease filters by hand ^ Clean the filters with a soft nylon brush in a mild solution of hot water and a little washing-up liquid. Do not use "neat" washing-up liquid. Do not use: – cleaning agents containing descaling agents, – powder cleaners, cream cleaners or abrasive all-purpose cleaners.
Fitting and replacing the charcoal filters The cooker hood uses two charcoal filters in addition to the grease filters. The charcoal filters absorb normal kitchen odours and are fitted in the canopy below the air outlet grilles. New charcoal filters can be purchased from your Miele dealer, from the Miele Spare Parts Department or www.
Always replace the charcoal filters im - mediately if – the Charcoal filter sensor | lights up or – they are no longer effective at absorbing kitchen odours. They should, however, be replaced at least every 12 months. Used charcoal filters can be disposed of with normal household waste.
Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. , Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off. Let them cool down before you change them.
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Service Department (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.
1) Cut-out for feeding through the mains connection cable Safety distance between hob and cooker hood (S on the installation drawing) When planning the installation height of your cooker hood, the min.
Installation accessories 2 screw s8x7 0m m with 2 washers and 2 plugs 10 x 60 mm for securing the appliance to the wall. The screws and plugs are for use in concrete, aerated concrete, solid sand-lime brick, perforated brick and hollow block. For other types of construction, alternative suitable fixings will be required.
, All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable.
Total connected load ..........2 0 0W – Fan motor .................1 6 0W – Hob lighting .............2x2 0W Voltage ..................A C2 3 0V Frequency ..................5 0H z Fuse rating ....................5A Weight ......................2 0k g Fan performance according to EN 61591 Recirculation power with charcoal filters: Level 1 .
27.
Alteration rights reserved / 0212 M.-Nr. 09 315 850 / 00.
An important point after buying a device Miele DA 7090 W Aura (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Miele DA 7090 W Aura yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Miele DA 7090 W Aura - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Miele DA 7090 W Aura you will learn all the available features of the product, as well as information on its operation. The information that you get Miele DA 7090 W Aura will certainly help you make a decision on the purchase.
If you already are a holder of Miele DA 7090 W Aura, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Miele DA 7090 W Aura.
However, one of the most important roles played by the user manual is to help in solving problems with Miele DA 7090 W Aura. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Miele DA 7090 W Aura along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
