Instruction/ maintenance manual of the product 99-7400 Metra Electronics
Go to page of 8
99-7400 INSTALLA TION INSTRUCTIONS TOOLS REQUIRED Cutting tool Phillips screwdriver KIT COMPONENTS Radio Housing #1 Radio Housing #2 Faceplate #1 Faceplate #2 Bracket Set #9 Bracket Set #17 Bracket Se.
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (4) Phillips screws above the radio opening. Remove (1) Phillips screw below the left side of the radio opening. Remove (1) Phillips screw from each side of the dash trim bezel.
13 2 3 Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (1) #10 Phillips screw from each side of the center console. Unsnap the coin tray and remove (2) #10 Phillips screws exposed. Lift the storage box carpet out and remove (2) #10 Phillips screws exposed.
3 12 Using the scored lines as a guide, cut and remove the dashed portions of Faceplate #1. Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the dash trim bezel and remove. Remove (4) Phillips screws securing the factory head unit and disconnect the wiring.
11 4 Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) screws from the top of the dash trim bezel and remove the bezel. Remove (4) fasteners from the factory head unit and disconnect the wiring. 1 NISSAN Axxess 1989-90 2 Using the scored lines as a guide, cut and remove the dashed portions of Faceplate #1.
5 10 Using the scored lines as a guide, cut and remove the dashed portions of Faceplate #2. Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and (1) screw exposed in the top-right corner. Remove (2) Phillips screws above the climate controls.
9 6 Using the scored lines as a guide, cut and remove the dashed portions of Faceplate #2. Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the knobs from the climate controls. Using a small screwdriver, pry out on the climate control trim panel and remove.
7 8 3 Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) Phillips screws from the bottom of the dash trim bezel. Remove (2) Phillips screws above the radio opening. Unclip the dash trim bezel and disconnect the defroster and rear wiper wiring.
An important point after buying a device Metra Electronics 99-7400 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Metra Electronics 99-7400 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Metra Electronics 99-7400 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Metra Electronics 99-7400 you will learn all the available features of the product, as well as information on its operation. The information that you get Metra Electronics 99-7400 will certainly help you make a decision on the purchase.
If you already are a holder of Metra Electronics 99-7400, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Metra Electronics 99-7400.
However, one of the most important roles played by the user manual is to help in solving problems with Metra Electronics 99-7400. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Metra Electronics 99-7400 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center