Instruction/ maintenance manual of the product SS103-3A Macurco
Go to page of 5
1 MACURCO INC. CONTROLLERS & CARBON MONOXIDE DETECTORS SS103 - 3A, SS103 - 10A SS102H, SS102HC - 1 INSTALLATION & OPERATING INSTRUCTIONS WWW.MACURCO.
2 MACURCO CONTROLLERS & DETECTORS (CONT.) SS102HC - 1 SENSOR OPERATION The SS102HC - 1 is a microcomputer controlled sensor. It has a 2 1/2 minute warm up cycle, during which its outputs progressively increase from 1.0 to 2.1 volts. The internal switch must be set to volts.
3 MACURCO CONTROLLERS & DETECTORS (CONT.) SS103 OPERATION START - UP Turn the FAN sensitivity level pots to the center of their ranges. When power is fir st applied to the SS103 , only the Green “POWER” light should be on.
4 MACURCO CONTROLLER S & DETECTORS (CONT.) SETTING THE CONTROLS If your installation has no pre - determined Fan and Alarm set points, Macurco makes the following suggestions: Set the FAN 1 level 50% higher than the average time weighted average of carbon monoxide (CO), usual ly 50 ppm, that is desired in the facility.
5 Englewood, Colorado 80110 WWW.MACURCO.COM REV. 2/99.
An important point after buying a device Macurco SS103-3A (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Macurco SS103-3A yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Macurco SS103-3A - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Macurco SS103-3A you will learn all the available features of the product, as well as information on its operation. The information that you get Macurco SS103-3A will certainly help you make a decision on the purchase.
If you already are a holder of Macurco SS103-3A, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Macurco SS103-3A.
However, one of the most important roles played by the user manual is to help in solving problems with Macurco SS103-3A. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Macurco SS103-3A along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
