Instruction/ maintenance manual of the product GW-P227 YTQK LG
Go to page of 32
d.
2 Entry Important saf ety instruction Identification of parts Where to install Door removal Door replacement F eed water pipe installation Height adjustment Starting Adjusting the temperatures and f u.
Entry The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers ar e unique to this unit and not available to others. Y ou should r ecord requested information here and r etain this guide as a permanent record of your pur chase.
4 Introduction This appliance contains a small amount of isobutane refrigerant (R600a), natural gas with high environmental compatibility, but it is also combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged.
5 Introduction DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer : Take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children or infirm persons without supervision.
6 *Dispenser model • Parts, features, and options vary by model. Your model may not include every option. NOTE Freezer Compartment Refrigerator Compartment Milk product corner Lamp Shelf Lamp Automa.
7 Installation 1. Place your appliance where it is easy to use. 2. Avoid placing the unit near heat sources, direct sunlight or moisture. 3. To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.
8 Installation Door removal Failure to do so could result in death or serious injury. If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Electric Shock Hazard Disconnect electrical supply to refrigerator before installing.
9 Installation Door replacement Feed water pipe installation (*Dispenser model only) Pass the refrigerator laterally through the access door as shown in the right figure. Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm 2 ) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.
10 Height adjustment Level the door by inserting flat ( - type) driver into the groove of the left height adjusting screw and rotate it clockwise ( ). Level the door b y inserting flat ( - type) driver into the groove of the right height adjusting screw and rotate it clockwise ( ).
11 Operation Starting When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2 - 3 hours prior to filling it with fresh or frozen foods.
12 Operation *Dispenser model • Your model may not include every option. NOTE.
13 Operation This function save the display power Press the FREEZER and EXPRESS FRZ. buttons simultaneously and hold them for 5 seconds until the Ding sounds. All LED/LCDs will then turn ON, then OFF. When the power saving mode is activated, the display will remain off until the next time the door is opened.
Operation 14 • Reference : Hold your cup in place for a couple of seconds after dispensing ice or water so the last few drops go in to your cup instead of the floor. Dispenser use (on some model) Select among crushed ice, water, and cubed ice and press the push switch with a glass or other container.
Operation 15 Ice is lumped together When ice is lumped together, take the ice lumps out of the ice storage bin, break them into small pieces, and then place them into the ice storage bin again. When the ice maker produces too small or lumped together ice, the amount of water supplied to the ice maker need to adjusted.
16 Operation Throw away the ice (about 20 pieces) and water (about 7 glasses) first made after refrigerator installation. The first ice and water may include particles or odor from the feed water pipe or feed water box. This is necessary in case that the refrigerator has not been used for a long time.
17 Operation Refreshment center (Applicable to some models only) Open the refreshment center door. You can access the refreshment center without opening refrigerator door and thus saving electricity. Inner lamp is lit in refrigerator compartment when the refreshment center door opens.
18 Operation Shelf (Applicable to some models only) W ine holder (Applicable to some models only) You can store taller items such as a gallon container or bottles by simply pushing in front half of shelf underneath back half of shelf. Pull toward you to return to a full shelf.
Operation 19 Humidity control in the vegetable compartment The humidity can be controlled by adjusting the humidity control switch to the left/right when storing vegetables or fruits.
20 Miracle Zone T emperature T ransition Corner (Applicable to some models only) Miracle Zone (Applicable to some models only) By pressing the button, store vegetables, fruits or other types of food such as meat to be defrosted, raw fish, etc.
Suggestion on food storage 21 Location of foods (Refer to identification of parts) Store wine. Store small foods such as bread, snacks, etc.. Store various frozen foods such as meat, fish, ice cream, frozen snacks, etc.. Store small packed frozen food.
22 Storing foods Store fresh food in the refrigerator compartment. How food is frozen and thawed is an important factor in maintaining its freshness and flavor. Do not store food which goes bad easily at low temperatures, such as bananas, and melons.
23 Care and maintenance How to dismantle parts • Dismantling is done in the reverse sequence of assembly. Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged. NOTE • Not all bulbs will fit your refrigerator.
0 0 Suggestion on food storage 24 Care and maintenance To remove the lamp cover, press the protrusion under the lamp cover to the front and then pull the lamp cover out. Turn the bulb counterclockwise. Max. 40 W bulb for refrigerator is used and can be purchased at a service center.
25 Care and maintenance General information Cleaning During average length vacations, you will probably find it best to leave the refrigerator in operation.
26 Care and maintenance T rouble shooting Before calling for service, review this list. It may save you both time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Possible cause Refrigerator control is off.
Care and maintenance 27 Refrigerator compressor does not run. Occurrence T emperatures ar e too cold T emperature in the freezer is too cold but the refrigerator temperature is satisfactory . T emperature in the refrigerator is too warm but the freezer temperature is satisfactory .
28 Care and maintenance Sound and noise Occurrence Louder sound levels when refrigerator is on. Louder sound levels when compressor comes on. Moisture collects on the inside walls of the refrigerator . W ater/Moisture /Ice outside refrigerator Moisture forms on the outside of the refrigerator or between doors.
Care and maintenance 29 Odors in refrigerator Occurrence Door(s) will not close. Door(s) will not close. Drawers are difficult to move. Dispenser Dispenser will not dispense ice Opening/Closing of doors/Drawers Possible cause Food is touching shelf on top of the drawer Track that drawer slides on is dirty.
30 Dispenser will not dispense ice. Ice dispenser is jammed. Occurrence W ater has an odd taste and/or odor . Dispenser will not dispense water . Possible cause Water has been in the tank for too long. Unit not properly connected to cold water line. This sound is normally made when automatically made ice is dropped into ice storage bin.
.
P/NO : MFL38287406 Printed in Poland.
An important point after buying a device LG GW-P227 YTQK (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought LG GW-P227 YTQK yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data LG GW-P227 YTQK - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, LG GW-P227 YTQK you will learn all the available features of the product, as well as information on its operation. The information that you get LG GW-P227 YTQK will certainly help you make a decision on the purchase.
If you already are a holder of LG GW-P227 YTQK, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime LG GW-P227 YTQK.
However, one of the most important roles played by the user manual is to help in solving problems with LG GW-P227 YTQK. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device LG GW-P227 YTQK along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
