Instruction/ maintenance manual of the product LRE30755S LG Electronics
Go to page of 16
Installation Manual Electric Range LRE30451S / LRE30755S Please read these instructions thoroughly before installing and operating the range. P/No.: 3828W5U0512 Website: http://us.
2 P ARTS PROVIDED 1 BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose all plastic bags after unpacking the range. Never allow children to play with packing materials.
3 INST ALLA TION DRA WINGS IMPORT ANT SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than 12 mm from any adjacent surface.
3, 4 - Wire electrical wall Receptacle types Conduit connection plate is used for the installation of power cord or conduit. For power cord, install it with conduit connection plate as manufacturer supplied.
5 Install the power cord as follows: For power cord installations, Hook the strain relief over the power cord hole (1 3 / 8 ”) located below the rear of drawer body. Insert the power cord through the strain relief and tighten it. (Refer to Figure 5.
6 Par t 3 ELECTRICAL CONNECTIONS 1. Remove the 3 nuts from the terminal block. ( Refer to Figure 7.) Remove the ground screw and washer retain them. 2. Cut the center portion of ground strap as shown Figure 7. Do not discard any screws. 3. Attach the ground wire with the ground screw and washer.
7 Par t 3 ELECTRICAL CONNECTIONS Third, connect the wires. If bare wire is used, connect with adapter lugs as shown in Figures 11 and 12. 1. Insert the end of each wire (L1, L2, Neutral) into the each lug. Tighten the clamping screw. 2. Remove the 3 nuts from the terminal block and retain them.
Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the three screws. ANTI-TIP DEVICE INST ALLA TION Note To install Anti-tip bracket, release the leveling leg.
Manual de instalación Estufa eléctrica LRE30451S / LRE30755S Sír vase leer cuidadosamente estas instrucciones antes de instalar y poner a funcionar la estufa.
2 PIEZAS PROVIST AS 1 ANTES DE COMENZAR Antes de usar la estufa, quite todas las cintas y materiales de empaque. Después de desempacar la estufa deseche todas las bolsas de plástico. Nunca permita que los niños jueguen con los materiales de empaque.
3 ILUSTRACIONES DE INST ALACIÓN IMPORT ANTE GUÁRDELO PARA EL USO DEL INSPECTOR LOCAL DE INSTALACIONES ELÉCTRICAS. HOLGURAS Y DIMENSIONES (Figura 1) Consulte la figura 1 a continuación para la instalación de la estufa. Si se va a instalar en CANADÁ, una estufa autónoma no podrá instalarse a menos de 12 mm de cualquier superficie adyacente.
3, Tipos de tomacorriente de pared de 4 alambres. Para la instalación del cable de alimentación o de conducto portacables se deben usar placas de conexión para conectar a conductos portacables. El cable de alimentación deberá instalarse con la placa de conexión de conductos portacables provista por el fabricante.
5 Instale el cable de alimentación como sigue: Para las instalaciones del cable de alimentación, enganche el tensor de alivio al orificio del cable de alimentación (1 3 / 8 ” (3.5 cm)) ubicado debajo de la parte posterior del cuerpo del cajón. Inserte el cable de alimentación a través del tensor de alivio y apriételo.
6 Sección 3 CONEXIONES ELÉCTRICAS 1. Quite las 3 tuercas del bloque de terminales . (Consulte la Figura 7.) Quite el tornillo de tierra y la arandela y guárdelos. 2. Corte la parte central de la cinta de tierra como se muestra en la figura 7. No deseche los tornillos.
7 Sección 3 CONEXIONES ELÉCTRICAS En tercer lugar conecte los alambres. Si usa alambre desnudo, conecte con adaptadores de orejetas, como se muestra en las Figuras 11 y 12. 1. Inserte el extremo de cada alambre (L1, L2, Neutral) en cada orejeta. Apriete los tornillos de apriete.
Reponga la cubierta de acceso en la parte posterior de la estufa. Para reponer la cubierta de alambre, inserte las salientes dobles en las cavidades ubicadas debajo de la abertura y apriete los tres tornillos. INST ALACIÓN DEL DISPOSITIVO ANTI-VOLCADURAS Nota Para la instalaci ó n de la m é nsula anti-volcaduras, libere la pata niveladora.
An important point after buying a device LG Electronics LRE30755S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought LG Electronics LRE30755S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data LG Electronics LRE30755S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, LG Electronics LRE30755S you will learn all the available features of the product, as well as information on its operation. The information that you get LG Electronics LRE30755S will certainly help you make a decision on the purchase.
If you already are a holder of LG Electronics LRE30755S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime LG Electronics LRE30755S.
However, one of the most important roles played by the user manual is to help in solving problems with LG Electronics LRE30755S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device LG Electronics LRE30755S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
