Instruction/ maintenance manual of the product D1453CF LG
Go to page of 36
O WNER’S MANU AL WA SHING MA CHINE WM0642H* P/ NO : MFL312 45123 Please re ad this manual ca re fully bef ore operating your set and re tain it f or futu re re fe rence. DISH WA SHER O WNER'S MANU AL Bef ore beginning installation, r ead these instructions car efully .
CONTENTS ................................ 2 IMPORTANT SAFETY INSTRUCTIONS Important safety instructions .............. 3 Read all instructions before use ........ 4 Save these instructions ...................... 5 INSTALLATION INSTRUCTIONS Prepare cupboard opening .
For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, injury to persons, or death. READ ALL INSTRUCTIONS AND EXPLANATION OF THE INSTALLATION BEFORE USE W ARNING You can be killed or seriously injured if you don’t follow instructions.
4 • Please read this manual carefully before using the dishwasher for the first time. • This manual contains very important notes regarding the installation, use and maintenance of your dishwasher . • The manufacturer can not be responsible for problems caused by ignoring these safety and caution instructions.
5 IMPORT ANT SAFET Y INSTRUCTIONS Read all instructions before use WARNING T o reduce the risk of fire, electric shock, or injury to persons when using the dishwasher , follow basic precautions, including the following: • Do not use any kinds of solvent in your dishwasher.
6 IMPORT ANT SAFET Y INSTRUCTIONS CAUTION The instructions shall state the substance of the following : This appliance is not intended for use by persons (including children) with reduced physical, se.
• A qualified electrician/plumber or competent person should carry out any electrical/ plumbing work required to install this appliance. WARNING 1. This appliance must be supplied with correct ratin.
• If the height of the cupboard is below 850mm, you should remove the top table by unscrewing the 2 screws. (T wo from rear) CAUTION 1. Lay the dishwasher on its back.
1. If the end of drain hose does not fit to the drain line, use a rubber connector(not supplied) that is resistant to heat and detergent. 2. This should be available from a plumbing shop or DIY merchants. 3. There are two typical connections as shown in Figure A, B.
10 • This dishwasher may be fed with either hot or cold water. If the water can not be maintained below 65ºC, the dishwasher must be connected to cold water. • When connecting, you may use sealant tape or sealing compound to avoid water leaks. • Make sure that the line is not kinked or sharply bent.
P ARTS NAME 11 1. Control Panel 2. Door Handle 3. Front Cover 4. Lower Cover 5. Display Window 6. Power Button 7. Drain Hose 8. Inlet Hose 9. Power Cord 10. Adjustable Leg 11. Upper Rack 12. Cutlery Basket 13. Detergent And Rinse Aid Dispenser 14. Vapor Vent Cover 15.
12 FUNCTION OF CONTR OL BUT T ON MODEL : D1453W(L,M,T ,B,C,D ,A)F(B,U) MODEL : D1463W(L,M,T ,B,C,D ,A)F(B,U) KD -C705NW / KD -C705NT.
13 SMARTDIAGNOSIS ™ function is available only for the products with a SMARTDIAGNOSIS ™ mark. (Refer to Page 32.).
① Programme • Press the cycle that corresponds to your desired wash cycle. ② Rinse • Repeated pressing of the Spray and Half Load button will select Extra Hot, Rinse+, Extra Hot & Rinse+. • If you select the Extra Hot ( ) function, the operating temperature will be up to 80 ℃ .
■ Method 1 1) Check the water hardness in your area. (Your water utility company can help you with this.) 2) Set the softening system level of your dishwasher according to the water hardness level. Refer to Step 2. ■ Method 2 1) Check your water hardness by using test strip.
16 Step 4. A dding Rinse Aid ■ For filling Step 3. Salt F illing Fill the regenerating salt container before starting the washing programme . Once you have filled with salt you must run the Quick course immediately to remove salt and salt water around the tub in order to prevent corrosion.
1 2 3 4 5 6 7 8 17 2. C utler y Rack 3. Upper Rack 1. C utler y Basket 1 2 3 4 5 6 7 ④ ④ ⑤ ① ② ① ④ ⑦ ① ② ① ⑤ ④ b b a b f c f b 4.
18 Daily use load 1. Cutlery Basket 2. Cutlery Rack 3. Upper Rack 4. Lower Rack HOW T O USE AND OPER A TE • Do not use the pot and pan with plastic handle.
NOTE Non Dishwasher Safe Items The combination of high water temperatures and dishwasher detergent may damage particular items, therefore we do not recommend using the dishwasher to wash the following.
• T o prevent injuries, place knives and other utensils with sharp points on the cutlery rack. • If you want to load them in the cutlery basket, place them with the pointed edges facing downwards. WARNING 20 2. C utler y Basket Place forks and spoons in the cutlery basket with their handles downwards.
21 Plates should be positioned upwards with the plate bottom facing the front of the rack. Cups, glasses and bowls must be positioned upside down. ■ How to fold down Take care not to obstruct the rotation of the spray arms. To make it easier to load larger dishes, the front row of tines can be folded down .
22 How to fold down Long stem glassware can be placed without interference from the lowered tines. • Pull up the tine • Rotate the tine Take care not to obstruct the rotation of the spray arm under the upper rack. To make it easier to load larger cups or glasses, the left side row of tines can be folded down.
23 Push button to open Place proper detergent into this compartment When using tablets, place them onto the inside surface of the door . The use of some combined detergent/rinse aid tablets can cause the dispenser to remain shut during the wash. HOW T O USE AND OPER A TE 5.
24 6. Refilling ■ For refilling Rinse Aid Depending on the dosage setting and the number of washes, the chamber may need to be topped up, approximately once a month. The rinse aid level can be checked by two methods. • By the indicator window on the dispenser when the dishwasher door is fully open.
25 7. Dr ying ■ To assist drying, we recommend that the door be partially opened after the cycle. The display will indicate Cd(cool dry) for a further 60 minutes after the end of the cycle time. It can be interrupted or terminated by simply opening the door.
26 1. Press the P ow er button 2. Check there is rinse aid and salt The corresponding indicator lights will illuminate if refilling is required. 3. Open the do or and check the filters Ensure they are clean and properly positioned. (See User Maintenance Instructions) 4.
27 27 ▶ Running time may vary according to the water temperature, water pressure and voltage. ▶ Running time doesn ’ t include Cool Dry - 60min. According to the degree of soiling, the programme automatically adjusts the washing time and temperature.
28 28 T o prevent trouble and poor operating, it is important to check filters and spray arms at regular intervals. Filters • Remove the lower rack first. • Turn the mesh filter counterclockwise. • Take out the mesh filter, upper STS filter and outer filter.
29 29 • If a problem occurs check below to see whether this can be solved. • In the unlikely event that the problem cannot be rectified, please contact a service engineer . Problem No lights come on when the power is turned on. • Check the plug.
30 30 Problem The display shows OE code. (W ater is not pumped away .) • The drain hose is kinked. • The filter is clogged. • Motor trouble. (W ashing motor or Drain motor) The display shows IE code. • Water is not supplied. • Water tap is not opened.
31 Code Description The display shows PF code This indicates there was a power failure. This function protects the dishwasher in the event that the power goes out or the power to the unit is disrupted. When power is returned, and a button is pushed, this will display for 3 seconds and then go away .
Only use this feature when instructed to do so by the call centre. The transmission sounds similar to a fax machine, and so has no meaning except to the call centre. SMARTDIAGNOSIS™ can not be activated if the dishwasher does not power up. If this happens, then troubleshooting must be done without SMARTDIAGNOSIS™.
KD-C705NW / KD-C705NT D1453W(L,M,T,B,C,D,A)F D1463W(L,M,T,B,C,D,A)F D1453W(L,M,T,B,C,D,A)U D1463W(L,M,T,B,C,D,A)U D1453W(L,M,T,B,C,D,A)B D1463W(L,M,T,B,C,D,A)B 33 SPECIFICA TION Capacity 14 Place settings Weight See rating label Power Supply See rating label Power Consumption 1,900 W 0.
34 OPERA TING DA T A Product fiche_commission Delegated Regulation(EU) No 1059/2010 Supplier ’ s name or trade mark LG Supplier ’ s model D1453*** D1463*** KD-C705** Rated capacity 14 PS Energy ef.
35 MEMO.
Y ou may also find owner's manual in video ver sion at f ollowing link www .lg. com/ steamdishwasher CUST OMER SERVICES T el. Fa x . L GEUK SER VICE WEB-SITE F or U.K . Customer : +44-(0) 844 847 L GLG(5454) : +44-(0) 844 847 1413 : http://www .lg.
An important point after buying a device LG D1453CF (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought LG D1453CF yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data LG D1453CF - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, LG D1453CF you will learn all the available features of the product, as well as information on its operation. The information that you get LG D1453CF will certainly help you make a decision on the purchase.
If you already are a holder of LG D1453CF, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime LG D1453CF.
However, one of the most important roles played by the user manual is to help in solving problems with LG D1453CF. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device LG D1453CF along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
