Instruction/ maintenance manual of the product EBVPFPM Lennox Hearth
Go to page of 24
1 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. HOMEOWNER'S CARE AND OPERA TION INSTRUCTIONS MODELS RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids in the vicin- ity of this or any other appliance.
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. These appliances are designed to operate on natural or propane gas only. Input of millivolt models is shown in the fol- lowing table: CONGRATULATIONS! In selecting this LENNOX B-Vented Gas Appliance you have chosen the finest and most dependable fireplace to be found anywhere.
3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea.
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 2 Note: The piezo ignitor is located on the modesty panel - see Figure 1. To ease door closure, depress the catch to place it in its retracted position, then close the door. Operation of millivolt and electronic gas con- trol systems are different.
5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Outside Combustion Air Controls Many appliances are equipped, when installed, with an outside (make-up air) vent system that is designed to provide the appliance with outside make-up air for combustion when in operation.
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Manual-Reset Safety Limit Switch This appliance is equipped with a manual- reset blocked flue safety limit switch.
7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Periodically (After the Burning Season) Maintenance Task Accomplishing Person Procedure Cleaning Firebox Interior Check Flame Patterns and Flame Heig.
8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Refer to Figure 6 and remove the front glass enclosure panel as follows: 1. Remove the top bustle, and the top louver assembly or radiant panel. Then remove the bottom bustle. 2. Open the control compartment access panel.
9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Log Placement The log set is located within the firebox area. One plastic bag of glowing embers, one plastic bag of decorative volcanic stone and one bag of vermiculate, is located in the bottom compart- ment.
10 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Electronic Appliance Checkout To light the burner, refer to the lighting instruc- tions on page 16 and 17 . Ensure the ignitor lights the pilot. The pilot flame should engulf the flame sensor as shown in Figure 12 .
11 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Arch Door Kits Two types of arch door kits are available for the Multi-Open Series. Both types of kits are easy to install and do not require hardware to attach them to the standard door frame. These kits can be retrofitted to previously installed Multi-Open Series appliances.
12 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Touch-Up Paint (Charcoal) Kit 90L74 TPK-C Touch-Up Paint Kit Repair of minor scratches and discoloration of the appliance charcoal painted cabinet sur- faces may be accomplished with the touch-up paint kit.
13 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED Polished Brass and Brushed Stainless Louvers Kits Decorative louvers are available for use with all Multi-Open Series appliances. These louvers are designed to replace the standard radiant panels that are provided with the appliance.
14 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED T all Arch Pane Door Style View Doors Continued - Style View Doors also come in a T all Arch Pane Design. T wo distinctive grille kits, the “ Crescents ” and “ Sunrise ” design, are also offered seperately .
15 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTES:.
16 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted with a piezo ignitor. When lighting the pilot, follow these instructions exactly.
17 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT INSTRUCTIONS D'ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Cet appareil est muni d ’ une veilleuse qui doit ê tre allum é e avec un allumeur pi é zo- é lectrique.
18 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. A. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
19 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE — ELECTRONIC INSTRUCTIONS D’ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Lorsque vous allumez l ’ appareil, suivez exactement ces instruc- tions.
20 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE MILLIVOL T GAS CONTROL SYSTEM 1. Spark ignitor will not light pilot after repeated triggering of ignitor button. 2. Pilot will not stay lit after carefully following the lighting instructions.
21 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION See Below. Disconnect the two black wires from the wire nuts. Test switch(s) for continuity with a multimeter.
22 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS GAS CONTROLS — HONEYWELL ELECTRONIC GAS CONTROLS — SIT MILLIVOLT GAS ORIFICES — SIT AND HONEYWELL SYSTEMS . o NN O I T P I R C S E D l a r u t a Ne n a p o r P . o N t r a P. y t Q.
23 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS LIST . o NN O I T P I R C S E D e n a p o r P d n a l a r u t a N . o N t r a P. y t Q. y t Q. y t Q. y t Q T S V B EF P V B EL C V B ER C V B E a 1. n i 4 2 - l a o c r a h c , t n a i d a R r e p p UY E 5 8 8 1 9 - B Le n o n1 1 1 b 1.
24 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Printed in U.S.A. © 2004 by LENNOX HEARTH PRODUCTS P/N 875,026M REV. B 01/2007 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
An important point after buying a device Lennox Hearth EBVPFPM (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lennox Hearth EBVPFPM yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lennox Hearth EBVPFPM - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lennox Hearth EBVPFPM you will learn all the available features of the product, as well as information on its operation. The information that you get Lennox Hearth EBVPFPM will certainly help you make a decision on the purchase.
If you already are a holder of Lennox Hearth EBVPFPM, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lennox Hearth EBVPFPM.
However, one of the most important roles played by the user manual is to help in solving problems with Lennox Hearth EBVPFPM. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lennox Hearth EBVPFPM along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
