

MATERIAL SAFETY DATA SHEET
Lanier Worldwide, Inc. 2300 Parklake Drive, NE Atlanta, GA USA 30345- 2979 Emergency Telephone: 800-526-4371
Color Developer – Cyan
MSDS No.
Developer for Lanier LP036c Development Unit Type 5000 Color Cyan Lanier LP036c Mixture
Supersedes:
None 06/04/2003 EH&S Department 770-496-9500 Larry Choskey, Manager, CEH&S Walter Fricke, Manager, Safety & Environment, Lanier Worldwide, Inc. Im Taubental D-41468 Neuss, Germany +49-2131-387-177
Contact:
Section 2: Composition / Information on Ingredients PERCENT CAS No. EXPOSURE LIMITS SOURCE Polyester resin > 80 Confidential Not listed N/a Acrylic resin < 10 Confidential Not listed N/a Silicon compound < 3 7631-86-9 Not listed N/a Organic pigment < 10 147-14-8 Not listed N/a
Section 3: Hazards Identification HMIS Rating: FLAMMABILITY = 1 HEALTH = 1 REACTIVITY = 0 SPECIAL = none Health Hazards, Immediate and Potential): Primary Entry Routes: Inhalation: Yes Skin: No Ingestion: No Medical conditions aggravated by exposure: N/A Chronic Effects: No data is available on this product. Carcinogenicity: This product does not contain the carcinogenic substances, which are listed in NTP, IARC, and are regulated by OSHA.
In case of contact, immediately flush eyes with water for 15 minutes. Get medical attention if needed. Skin Contact: Wash with soap and water. Ingestion: Dilute stomach contents with several
Gargle with water. Remove to fresh air if effects occur. Get medical attention if needed.
Eye Contact:
glasses of water. Get medical attention. Section 5: Fire Fighting Measures Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none Special protective equipment for fire fighters: none UEL: n/a LEL: n/a
your document management partner
European

MATERIAL SAFETY DATA SHEET Page 2 of 3 CP-736
Section 6: Accidental Release Measures Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold water. Miscellaneous: Keep product out of sewers and watercourses. Personal protection: Avoid inhalation of dust.
Cleanse skin after contact before breaks or meals, and end of workday. Do not handle in areas where the wind blows. Minimize the breathing of dust. Special Storage: Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)
Section 8: Exposure Control and Personal Protection Information: Respiratory Protection: none required under normal use. Hand Protection: none required under normal use. Eye Protection: none required under normal use. Skin Protection: none required under normal use.
Section 9: Physical and Chemical Properties CHARACTERISTICS: Appearance: Cyan Melting point: N/a Form: Powder Vapor pressure: N/a Odor: Slight plastic odor Vapor density: N/a Solubility in Water: Insoluble Evaporation rate: N/a Specific gravity: N/a Boiling point: N/a Density: 1.2 g/cm3 Section 10: Stability and Reactivity Conditions to avoid: none Materials to avoid: none Stability: Stable Hazardous decomposition products: will not occur
Section 11: Toxicological Information: Ames test negative Acute skin irritation: Non-irritant Acute oral toxicity: 5000mg/kg (rat) Acute allergenic effects: non-skin sensitive Special effects: Carcinogenicity: No data is available on this product.
Section 12: Environmental / Ecological Information Acute toxicity to fish: not available Bioaccumulation: Not known in bioaccumulation Persistence/Degradability: Not known Acute toxicity to daphnia: Not available Algae inhibition test: Not available
Section 13: Disposal Consideration Used developer should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose or spilled developer.
Section 14: Transportation Information International regulations: RID/ADR Not applicable ICAO-TI/ATA-DGR Not applicable DOT 49 CFR Not applicable UN Classification Number Not applicable ADNR Not applicable IMDG Code Not applicable Specific precautionary transport measures: Avoid direct sunlight. Do not keep over 35?C (95?F). Specific material to avoid: None in normal use.

MATERIAL SAFETY DATA SHEET Page 2 of 3 CP-736
Section 16: Miscellaneous Information Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser. Therefore, although reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no warranties, makes no representations, and assumes no responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for consequences of its use. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the only hazards that exist.
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.