Instruction/ maintenance manual of the product PH1-2000D Kole Audio
Go to page of 20
.
PH4-800 / PH4-1000 / PH4-1400 PH1-2000D / PH1-4000D / PH1-5500D PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 OWNERS MANU AL.
.
- 2 - INTRODUCTION Kole Audio amplifiers provide high-performance sound reinforcement for your mobile audio equipment. Its versatility enables compatibility with optional Equalizers, Frequency Dividing Crossover Networks, and other audio processors in a customized system.
- 3 - Before beginning the installation, consider the following: 1. Do you plan to add additional mobile electronics equipment in the future? If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left and cooling requirements are met.
- 4 - CONNECTING THE POWER (Fig.1) CAUTION: AS A PRECAUTION, DISCONNECT THE POWER WIRE FROM THE BATTERY WHILE MAKING THE POWER AND GROUND CONNECTIONS TO THE AMPLIFIER. 4/8 GAUGE (Thicker if planning for additional Amplifiers) wire is recommended for both the power and ground wires.
- 5 - RCA input jacks These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system.
- 6 - High pass x-over frequency control This control is used to select the desired high pass x-over frequency. PH4-800/PH4-1000/PH4-1400 : The frequency can be adjusted between 40Hz and 250Hz. PH2-700/PH2-1000/PH2-1500/PH2-2000/PH2-2400 : The frequency can be adjusted between 50Hz and 500Hz.
- 7 - LED Will illuminate GREEN to indicate the amplifier is on and operating normally, and will be illuminated RED if the amplifier shuts down due to short circuit, DC offset, or overheating detected by on board protection circuitry. REMOTE Controls the subwoofer amplifier gain, from a remote location for ease of adjustment during listening.
- 8 - MASTER MODE CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D 1.Lowest Recommended Impedance is 1ohm mono. 2.RCA Inputs are connected to both Left and Right channels 3.
- 9 - STRAPPED CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D STRAPPED 2-4ohms 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 10 - 2 CHANNEL STEREO CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 2 CHANNEL BRIDGED CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 11 - 2 CHANNEL TRI MODE CONFIGURATION PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 12 - 4 CHANNEL STEREO CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 13 - 4 CHANNEL BRIDGED CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest recommended impedance is 4ohm bridged mono 2.RCA Inputs are connected to both Left &Right channels 3.
- 14 - 4 CHANNEL TRI MODE CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 3CH 4-8 Ohms 4CH 4-8 Ohms WOOFER 1CH 4-8 Ohms WOOFER 2CH 4-8 Ohms HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 15 - TROUBLE SHOOTING GUIDE Check fuses in amplifier. Be sure Turn-on lead is connected Repair power wire or connections Check connections to radio Check fuse Inspect for short circuit or an open connection. Reverse Left and Right RCA inputs to determine if it is occurring before the amp.
- 16 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH2-700 700W 2 X 150W 2 X 180W 1 X 360W 0.
- 17 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm POWER OUTPUT @1Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH4-800 800W 4 X 80W 4 X 95W - 2 X 190W 0.
- 18 - W ARNINGS Investigate the layout of your automobile throughly before drilling or cutting any holes. Take care when to work near the gas tanks, lines, or hydraulic lines, and electrical wiring. Don't use power amplifier unmounted. Attach this system securely to the automobile to prevent damage, particularly in the event of an accident.
An important point after buying a device Kole Audio PH1-2000D (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kole Audio PH1-2000D yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kole Audio PH1-2000D - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kole Audio PH1-2000D you will learn all the available features of the product, as well as information on its operation. The information that you get Kole Audio PH1-2000D will certainly help you make a decision on the purchase.
If you already are a holder of Kole Audio PH1-2000D, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kole Audio PH1-2000D.
However, one of the most important roles played by the user manual is to help in solving problems with Kole Audio PH1-2000D. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kole Audio PH1-2000D along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
