Instruction/ maintenance manual of the product 3SF23/9HI Kidde
Go to page of 10
1 Y our home is protected with a KIDDE Fyrnetics alarm/s Please read through our guide in full. It should be retained for future reference. Cut out page 6 and pin up near your Consumer Unit/Fuse Bo x. Kidde Fyrnetics recommends for maximum protection that both ionisation and opti- cal (photo-electric) smoke alarms be installed.
1. Alarm Range Interconnectable 230V Hard Wired Alarms 1SF23/9HIR: 1SF23/9HI: 2SF23/9HIR: 2SF23/9HI: 3SF23/9HIR: 3SF23/9HI: 2. Impor tant Information This alarm is designed for installation by a qualified electrician, in accordance with the latest I.E.
b. Alarm T ypes • Ionisation (Ion) alarms are the most common type and provide early detection, especially against fast flaming fires. Most suitable for dining and living room areas. Ion alarms contain 0.9 microcurie of Americium 241, a radioactive material.
b. T esting • Utilise the test button to test the alarm. Do not use naked flames as this does not replicate smoke and may cause physical damage to the alarm. T est all your alarms weekly – remember they are life saving devices, protecting the family and home.
ii. Slide scewdriver blade in recess to unlock from base. iii. Unclip and slide alarm as illustrated. iv . Note correct position of battery and install replacement type as listed below . The alarm cannot be replaced without a battery installed. v Reverse procedure to re-install alarm.
Kidde Safety Europe, Mathisen W ay , Colnbrook, SL3 0HB, UK. www . kiddefyrnetics.co.uk Installation Date: Alarm Model(s): Installer/Landlord: T el: Good Safety Habits Develop and practice a plan of escape: • Make a floor plan indicating all doors and windows and at least two escape routes from each room.
7.
6. Checking Batter y Back-up on R echargeable/Long Life Models • There is no user replaceable battery on rechargeable models. This will be indicated on the product; additionally there is no battery compartment. T o check charge on these models, switch off the alarms AC supply at the Consumer Unit/Fuse Box.
9. T roubleshooting • Always turn off the mains supply to AC alarms before checking connections etc.. 10. Useful Hints • Smoke/heat alarms can only operate correctly if smoke particles/heat reach the unit. Correct selection/siting and installation are covered in the installers manual, who fitted your alarm/s.
13. Limitations of Smoke/Heat Alarms Warning! Alarms are devices that can provide early warning of possible fires at a rea- sonable cost; however , alarms have sensing limitations. Ionisation type alarms offer a broad range of fire sensing capability but are better at detecting fast flaming fires than slow smouldering fires.
An important point after buying a device Kidde 3SF23/9HI (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kidde 3SF23/9HI yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kidde 3SF23/9HI - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kidde 3SF23/9HI you will learn all the available features of the product, as well as information on its operation. The information that you get Kidde 3SF23/9HI will certainly help you make a decision on the purchase.
If you already are a holder of Kidde 3SF23/9HI, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kidde 3SF23/9HI.
However, one of the most important roles played by the user manual is to help in solving problems with Kidde 3SF23/9HI. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kidde 3SF23/9HI along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
