Instruction/ maintenance manual of the product POWER MISER 153.335862 Kenmore
Go to page of 40
Owners Manual FOR POTABLE WATER HEATING ONLY NOT SUITABLE FOR SPACE HEATING NOT FOR USE IN MOBILE HOMES Model No. 153.335816 40 Gal. 153.335845 40 Gal. High Altitude L.R 153.335862 40 Gal. L.R 153.335916 50 Gal. 153.335942 50 Gal. High Altitude L.R 153.
Safety Precautions •,WARNING I Improper installation, adjustment, alteration, service or I maintenance can cause death, serious bodily injury, or property damage. Refer to this manual for assistance or consult your local Sears Service Center for further information.
Safety Precautions AWARNING A gas water heater cannot operate properly without the correct amount of air for combustion. Do not install in a confined area such a closet, unless you provide air as shown in the "Locating The New Water Heater" section.
Safety Precautions AWARNING ] The water heater wi_talled must be prop- [ erly vented to a chimney which terminates outdoors.[ Never operate the water heater unless it is vented to the [ outdoors and has adequate air supply to avoid risks of[ improper operation, explosion or asphyxiation.
Table of Contents Safety Precautions ............................................................................................................................................ 2-4 Table of Contents ...................................................
Customer Responsibilities Thank You for purchasing a Sears water heater. Properly installed and maintained, it should give you years of trouble free ser- vice. If you should decide that you want the new water heater profes- sionally installed by Sears call the local Sears Service Center or any Sears store.
Materials and Basic Tools Needed Materials Needed To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materi- als, depending On your type of"installation.
Installation Instructions Removing the Old Water Heater Turn "OFF" the gas supply to the water heater. •,WARNING ] If the main gas line shutoff serving all gas appliances is / used, also shut "off" the gas at each appliance. Leave all| gas appliances shut "off" until the water heater installation | s comp ete.
Installation Instructions Locating the New Water Heater You should carefully choose an indoor location for the new water heater, because the placement is a very important consideration for the safety of the occupants in the building and for the most economical use of the appliance.
Installation Instructions (cont'd) AWARNING A gas water heater cannot operate properly without the cor- rect amount of air for combustion. Do not install in a con- fined area such a closet, unless you provide air as shown in the "Locating The New Water Heater" section.
Installation Instructions (cont'd) Combustion Air and Ventilation for Appliances Located in Unconfined Spaces Unconfined Space is a space whose volume is not less than 50 cubic feet per 1,000 Btu per hour of the aggregate input rating of all appli- ances installed in that space.
Installation Instructions (cont'd) Water Piping AWARNING HO'I-I'ER WATER CAN SCALD: Water heaters are intended to =reduce hot water. Water heated to a temperature which will satisfy clothes washing, dish washing, and other sanitizing needs can scald and permanently injure you upon contact.
Installation Instructions (cont'd) Temperature-Pressure Relief Valve _,WARNING At the time of manufacture this water heater was provided with a combination temperature-presseres relief valve cert.
Installation Instructions (cont'd) Filling the Water Heater A CAUTION J Never use this water heater unless it is completely filed with water. To prevent damage to the tank, the tank must be filled with water. Water must flow from the hot water faucet before turn ng ON' gas to the water heater.
Installation Instructions (cont'd) USE WITHOUT POWER CORD (cont'd) 3. A standard ½" conduit opening has been made in the water beater junction box for the conduit connection. 4. Use wire nuts and connect the power supply wiring to the wires inside the water heater's junction box.
Installation Instructions (cont'd) Venting (cont'd) AWARNING J Be sure vent pipe is properly connected to prevent escape of J dangerous flue gases which could cause deadly asphyxiation. J AWARNING Chemical vapor corrosion of the flue and vent system may occur if air for combustion contains certain chemical vapors.
Installation Instructions (cont'd) VENTING SYSTEM EXAMPLE INSTALLATIONS FOR ALL MODELS (cont'd) i - . 2. Horizontal runs require a minimum ¼ rise per foot. 7- 13"HIN. l 35' MAX. 1 3. A vertical run can be no more than 20'. 4.
Installation Instructions (cont'd) Venting (cont'd) CUTTING OPENING THROUGH AN OUTSIDE WALL AND COLLAR INSTALLATION After reading the manual and you have determined the location of the opening in the wall, (using the drawing below), cut a 3_" hole through an exterior wall.
Installation Instructions (cont'd) Gas Piping &WARNING Make sure the gas supplied is the same type listed on the model rating plate. The inlet gas pressure must not exceed 10.5 in. water column (2.6kPa) for natural gas or 13 in. water column (3.
Installation Instructions (cont'd) Installation Checklist BEFORE LIGHTING THE PILOT: VENT PIPE TO OUTDOORS Check the gas lines for leaks. a. Use a soapy water solution• DO NOT test for gas leaks usinga match or open flame. b. Brush the soapy water solution on all gas pipes, joints and fittings.
Operating Instructions This water heater is equipped with an electrically operated vent- ing system and a standing pilot. For the burner to come on, the water heater thermostat must call for heat. Then the system will begin sequencing, each section proving itself before gas is allowed to flow to the burner.
Operating Instructions Lighting AWARNING BEFORE LIGHTING [PROPANE (L,P.) GAS WATER HEATERS]: Propane (LR) gas is heavier than air. Should there be a leak in the system, the gas will settle near the ground.
Operating Instructions (cont'd) Lighting label on the water heater as it appears above the thermostat I FOR YOUR SAFETY READ BEFORE LIGHTING I WARNING If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
Operating Instructions (cont'd) Temperature Regulation Due to the nature of the typical gas water heater, the water tem- perature in certain situations may vary up to 30°F higher or lower at the point of use such as, bathtubs, showers, sink, etc.
Service and Adjustment Tank (Sediment) Cleaning Sediment build-up on the tank bottom may create varying amounts of noise, and if leiCt in the tank will cause premature tank failure. In some water areas, you may not be able to drain all sediment deposits by simply draining the tank.
Service and Adjustment (cont'd) L.P. Gas Control Valve & Burner Assembly Replacement Information Draining The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.
Service and Adjustment (cont'd) Drain Valve Washer Replacement NOTE: For replacement, use a _z" x '_/_"x ¼" thick washer available at your nearest hardware store. For ordering replace- ment washers, refer to the "Repair Parts" section.
Troubleshooting Guide Start Up Conditions THERMAL EXPANSION Water supply systems may, because of such events as high line pressure, frequent cut-offs, the effects of water hammer among others, have installed devices such as pressure reducing valves, check valves, back flowpreventers, etc.
Troubleshooting Guide (cont'd) CONDENSATION Whenever the water heater is filled with cold water, a certain amount of condensation will fornt while the burner is on. A water heater may appear to he leakingwhen in fact the water is condensation. This usually happens when: • When a new water heater is filled with cold water for the first time.
Troubleshooting Guide (cont'd) Operational Conditions (cont'd) "AIR" IN HOT WATER FAUCETS WATER IS TOO HOT AWARNING HYDROGEN GAS: Hydrogen gas can be produced in a hot water system that has not been used for a long period of time (generally two weeks or more).
Troubleshooting Guide (cont'd) Leakage Checkpoints Use this guide to check a "Leaking" water heater. Many suspect- ed "Leakers" are not leaking tanks.
Troubleshooting Guide (cont'd) _IWARNING I This troubleshooting guide has been supplied for use by quail- I tied service personnel who have a complete understanding of beth e ectric ty and gas. _ICAUTION I Label all wiring before disconnecting any wiring; to ensure correct reconnection.
Troubleshooting Guide (cont'd) Diagram for Electrical System Check on pages 34 and 35. 120V ONIOFF SWITCH, GAS PRESSURE SWITCH @ 120V GAS SOLENOID HI-LIMIT N._ sw_c...,c AIR PRESSURE SWITCH INDICATOR LIGHT 120V 0 NC AIR PRESSURE SWITCH (_ GROUND iv R= ACK ] I I I [ ®-.
Troubleshooting Guide (cont'd) ELECTRICAL SYSTEM CHECK (Use diagram on page 33) _,CAUTION I Label all wiring before disconnecting an)" wiring; to ensure correct reconnection. Failure to follow this instruction I could cause improper and possible dangerous operation, I I resulting in DEATH, SERIOUS BODILY INJURY, OR I t PROPERTY DAMAGE.
Troubleshooting Guide (cont'd) Check #5 to ground for 110/120 L.__ VO rs. I- Yes Check#9 for 110/120 volts. I No Yes Check venting manual reset switch. continued from facing page _o -t_hec_#_togrouod/r110,_20_o,ts. I-.-_o t Isindicator,_htoo? I I Yes Y I Replace indicator light.
Parts Order List POWER MISER TM 9 POWER VENT GAS WATER HEATERS MODEL NUMBERS: 153.335816 153.335845 153.335862 153.335916 153.335942 153.335962 40 Gal.
Parts Order List (cont'd) POWER MISER TM 9 POWER VENT GAS WATER HEATERS MODEL NUMBERS: 153.335816 40 Gal. 153.335845 40 Gal. High Altitude L.E 153.335862 40 Gal. L.E 153.335916 50 Gal. 153.335942 50 Gal. High Altitude L.E 153.335962 50 Gal. L.E KEY NO.
Parts Order List POWER MISER TM 9 POWER VENT GAS WATER HEATERS MODEL NUMBERS: 153.335816 40 Gal. 153.335845 40 Gal. High Altitude L.P. 153.335862 40 Gal. L.P. 153.335916 50 Gal. 153.335942 50 Gal. High Altitude L.P. 153.335962 50 Gal. L.P. 3 4 5 P 31€.
Parts Order List (cont'd) POWER MISER TM 9 POWER VENT GAS WATER HEATERS MODEL NUMBERS: 153.335816 40 Gal. 153.335845 40 Gal. High Altitude L.P. 153.335862 40 Gal. L.P. 153.335916 50 Gal. 153.335942 50 Gal. High Altitude L.R 153.335962 50 Gal. L.P.
Warranty About Your Warranty THE PRICE OF YOUR WATER HEATER DOES NOT INCLUDE A FREE CHECKUP SERVICE CALL. On Water Heater Installations Arranged By Sears, Sears warrants the installation. ON INSTALLATIONS NOT MADE BY SEARS AUTHORIZED CONTRACTORS: 1. Your Sears warranty applies to the product only.
An important point after buying a device Kenmore POWER MISER 153.335862 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kenmore POWER MISER 153.335862 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kenmore POWER MISER 153.335862 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kenmore POWER MISER 153.335862 you will learn all the available features of the product, as well as information on its operation. The information that you get Kenmore POWER MISER 153.335862 will certainly help you make a decision on the purchase.
If you already are a holder of Kenmore POWER MISER 153.335862, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kenmore POWER MISER 153.335862.
However, one of the most important roles played by the user manual is to help in solving problems with Kenmore POWER MISER 153.335862. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kenmore POWER MISER 153.335862 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
