Instruction/ maintenance manual of the product 8526119A Kenmore
Go to page of 19
E L ! T E Three-Speed Timed Bleach Automatic Washers Lavadoras autom_ticas con tres velocidades y distribuci6n temporizada de blanqueador Laveuses automatiques _ trois vitesses Distribution d'eau de Javel minut_e Sears Roebuck and Co., Hoffman Estates, IL 60179 U.
TABLE OF CONTENTS SERVICE .......................................................................................... 2 In the U.S.A ................................................................................... 2 In Canada .......................
Your purchase has added value because you can depend on Sears HomeCentraf _ for service. With over 2,400 Service Technicians and access to over 900,000 parts and accessories, we have the tools, parts, knowledge and skills to back our pledge: We Service What We Sell.
WASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. l_ his is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
INSTALLATION REQUIREMENTS Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the washer basket. Tools needed for connecting the drain hose and water inlet hoses: • Pliers that open to 19/16 in.
Recessed area or closet installation The dimensions shown are for the recommended spacing allowed, except the closet door ventilation openings. The dimensions shown for the closet door ventilation openings are the minimum required. olo 1. Front view 2.
• If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. • Do not ground to a gas pipe. • Check with a qualified electrician if you are not sure the washer is properly grounded.
3. Cut the shipping strap about 16 in. (41 cm) from plug end. Look forthe words "CUT HERE." Discard end with the cotter pins. Slide remainder of shipping strap from the power cord. You will use the remainder ofthe shipping strap later to secure the drain hose.
4. Using pliers, tighten the couplings with an additional two- thirds turn. NOTE: Do not overtighten. Damage to the valves can result. Clear the water lines 5. Run water through both faucets and inlet hoses, into a bucket or laundry tub, to get rid of particles in the water lines that might clog the inlet valve screens.
8. If the washer is not level, move the washer out slightly, tip back, prop up the front ofthe washer with the wood block and adjust the feet up or down as necessary. Repeat steps 5 through 8 until washer is level. 9. After the washer is in the final location and level, use a %e in.
WASHER USE F_ WA]ER LEVEL ULTRA CLEAN Fire Hazard Never place items in the washer that are dampened with gasoline or other flammable fluids, No washer can completely remove oil. Do not dry anything that has ever had any type of oil on it (including cooking oils).
• You may change to a higher level setting after the washer has started filling by turning the knob to a different setting. 6. Set the Water Temperature selector to the correct setting for the type of fabric and soils being washed. Use the warmest water safe for fabric.
This section describes the available wash cycles and will help you make the best cycle selections for your wash loads. Each cycle is designed for different types of fabric and soil levels. • The washer pauses briefly throughout each cycle. These pauses are normal.
Your new washer may make sounds your old one didn't. Because the sounds might be unfamiliar, you may be concerned about them. These sounds are normal. During washing When you select a small load size setting, your washer has a lower water level. This can cause a clicking sound from the upper part of the agitator.
Install and store your washer where it will not freeze. Because some water may stay in the hoses, freezing can damage your washer. If storing or moving your washer during freezing weather, winterize it. Non-use or vacation care: Operate your washer only when you are at home.
Washer continues to fill or drain, or the cycle seems stuck Does the drain hose fit too tightly in the standpipe, or is it taped to the standpipe? The drain hose should be loose yet fit securely. Do not seal the drain hose with tape. The hose needs an air gap.
Stains on load Gray whites, dingy colors • Didyou use enough detergent? Use enough detergent to remove soil and hold it in suspension. Add the manufacturer's recommended amounts. • Did you add fabric softener directly to the load? Use your fabric softener dispenser.
18.
iiiiiiiiiiiiiiiiiiiiiiiiiiii_ iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiiiiiii: iiiiiiiiii.
An important point after buying a device Kenmore 8526119A (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kenmore 8526119A yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kenmore 8526119A - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kenmore 8526119A you will learn all the available features of the product, as well as information on its operation. The information that you get Kenmore 8526119A will certainly help you make a decision on the purchase.
If you already are a holder of Kenmore 8526119A, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kenmore 8526119A.
However, one of the most important roles played by the user manual is to help in solving problems with Kenmore 8526119A. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kenmore 8526119A along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
