Instruction/ maintenance manual of the product 407.52301 Kenmore
Go to page of 16
Use & Care Guide Manual: de Uso y Cuidado English / Espa_ol Models, Modelos: 407.52301 i<enmo Dehum°difier Deshumidificador Sears Brands Management Corporatlon Hoffman Estates, IL 60179 U.
Package Contents ........................................ 2 Warranty ....................................................... 2 Safety Instructions ........................................ 3 Electrical Requirements ............................... 4 Installation .
IMPORTANT CAUTIONS FOR USING YOUR DEHUMIDIFIER. To reduce the risk of fire, electrical shock, injury, or damage to the dehumidifiers, these safet'j precautions must be followed: Safety • Do not place the power cord near a heater.
OBSERVE ALL LOCAL CODES AND ORDINANCES. DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER SUPPLY CORD GROUND PRONG. ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE A 11S-VOLT 60Hz, AC ONLY, 15A FUSED AND PROPERLY GROUNDED ELECTRI- CAL SUPLLY IS REQUIRED.
1. Remove the bucket from the dehumidifier (Fig. 1) 2, Gently pull at the back and front of the bucket to dislodge the bucket cover from the notches. (Fig. 2) Fig. 1 3. Locate and remove the accessory bag containing the 4 casters (Fig. 3) Pull Bucket Notch Fig.
1. Ti!t the dehumidifier no more than 45 ° and forcibly insert _he casters. Make sure the ring around the caster is flush against the bottom of the dehumidifier (Fig. 1) 45 > Fig. 1 Ring around caster • Install the dehumidifier on a tevet floor strong enough to support the unit with a full bucket of water.
CHOOSING THE PROPER LOCATION Use the dehumidifier: • in the basement to help prevent moisture damage. • in theikitchen, laundry room, bath- room,; and spalexercise areas that have _xcessive moisture. • to prevent moisture damage any- where books or valuables are stored.
(7) (9) (lp) (1.1) (12) (1,3) (4) (5) (2) POWER ONtOFF (1) Once the unit is plugged in, the POWER INDI- CATOR (t0) will light up. Pressing the Power button once will turn the unit ON and illuminate the digital display (9). The display will show the humidity level of the room in 5% increments down to 25%.
OPTIO N 1: EMPTYING MANUALLY 1. Pull out the bucket, g[asping the side handles, (Fig, 1) 2. Carry the bucket by grasping the front corneP of the bucket with one hand and the back of the bpcket with the other hand(Fig. 2) , 3. Empty the bucket and repIace the bucket in the dehumidifier, (Fig.
CLEANING THE AIR FILTER After 250 hours of operation the FILTER RESET indicator will light up to remind you to clean and change the air filter. It is recommended to periodically check the filter for excess dirt even if the FILTER RESET indicator is off.
PrOblem" Dehumidifier does not start. Possible Causes Dehumidifier is not operating as intended. The dehumidifier is un- plugged. The fuse is blown / cir- cuit breaker is tripped. Dehumidifier has reached the user set humidity level or the bucket is full Bucket is not in the )roper position.
Dehumidifier runs too much Frost appears on the coils The controls cannot be set or changed The area to be dehumidi- fied is too large. Doors and windows are open. The dehumidifier has recently been turned on or the room temperature is below 41°F. The compressor turns off and the fan continues to run for approximately 3 minutes at a fixed setting.
' ITEM # 52301 Moisture Removal per 24 hours 30 Pints per day (14.2 Liters per day) ,,,,,, i,, , ,, Power Consumption (W_ 410 Watts Bucket Capacity 8.5 Pints (4 Uters) , ,,,,, , ,, Power Source 115 V 160 HZ , _ ....... ,, ,, ,,,, Rated Current (Amps) 3.
Master Protection Agreements Congratulations on making a smart purchase. Your new Kenmore®product is de- signed and manufactured for years of dependable operation. But like all products, it may require preventive maintenance or repair from time to time.
SPANISH SECTION 15.
Your Home For troubleshooting, product manuals and expert advice: managemylife www.managemy|ife,¢om For repair- in your home - of all major brand appliances, |awn and garden equipment, or heating and.
An important point after buying a device Kenmore 407.52301 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kenmore 407.52301 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kenmore 407.52301 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kenmore 407.52301 you will learn all the available features of the product, as well as information on its operation. The information that you get Kenmore 407.52301 will certainly help you make a decision on the purchase.
If you already are a holder of Kenmore 407.52301, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kenmore 407.52301.
However, one of the most important roles played by the user manual is to help in solving problems with Kenmore 407.52301. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kenmore 407.52301 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
